The trailer wiring harness part # 118410 that you referenced is a confirmed fit for your 2007 Hyundai Entourage. It will work just fine on your vehicle that has incandescent bulbs and will easily work with the LEDs you have on your trailer. view full answer...
Thank you for all the details on your axle and bearings!
Your list of parts is dead on. The Dexter Electric Trailer Brake Kit w/ Parking Brakes # K23-103-104-00 is a great option if you are looking to add a parking brake. If you aren't planning on adding a parking brake you can use the Electric Trailer Brake Kit # AKEBRK-2.
The Dexter # K23-103-104-00 comes with the required hardware, but the Electric Trailer Brake Kit # AKEBRK-2 will require the Mounting Hardware # BRKH7 or two of the... view full answer...
For your 2007 Hyundai Entrourage, the factory sizes of tires are 225/70-16 and 235/60-17. I cannot recommend any other size tires for your vehicle.
For reference the 225/65-17 tires are 28.5 inches diameter with a 8.9 inch width and 5.8 inch sidewall. Your current 235/60R17 tires are 28.1 inches diameter with a 9.3 inch width and 5.6 inch sidewall. Changing your tires would decrease the amount of contact with the road and also decrease your wheel well clearances.
I recommend the... view full answer...
I believe you are referring to the list we have compiled that shows the top 20 weight distribution systems that owners of 2007 Hyundai Entourages have purchased. This does not mean that this is the best system for your application. The best way to pick out a weight distribution system is to base it off of the loaded tongue weight of your setup. You should note that the weight of any cargo behind the rear axle should also be considered as tongue weight.
I attached an FAQ article on determining... view full answer...
What I would do in your situation is cut off the square connector and install a 4-Pole Trailer End Connector # 18004 instead. This way the wiring harness # 118410 that you ordered will plug right in, and if you ever have to tow the trailer with a different vehicle it would work. You will need to wire the 4-way in by function to the 4 wires that got cut off. You can either use a power source to put voltage on the circuit so that you figure out what wire does what, or you can trace the wires... view full answer...
Go To Results