My dad used to have a 1967 Cadillac Sedan DeVille. I have been inside and out of the car helping him work on it. I think your best option is to use wiring harness # P239003HD. It has a 3-prong receptacle and the wiring for the bulb.
Better yet you could use # P230004HW which includes the heavier wire and receptacles along with relays to protect the old wiring on your Caddy. view full answer...
Attached are the complete instructions for the Curt Trailer Hitch Receiver # C12052 for your 1996 Cadillac DeVille and I have attached some clips from the instructions that you can check out. The part about drilling is step 3. This is shown with the pictures of the drill in the visual photo. view full answer...
I have attached the installation instructions for the Draw-Tite Trailer Hitch Receiver, part # 36267.
The installation requires no drilling and is really a pretty easy install. You just need to lower the exhaust and use the existing holes ion the frame on your Cadillac. Then raise the exhaust back into place and that's it.
To clean out the existing holes and weldnuts on your vehicle you can use part # 814092. view full answer...
The MagnaFlow Universal Stainless Steel Catalytic Converter # MF94006 is non-directional, meaning that it can be installed with either end as inlet and outlet. I confirmed this with my contact at MagnaFlow. Both ends have a 2-1/2-inch diameter. All catalytic converters for your 4.9L V8 1995 Cadillac DeVille are shown on the linked page. view full answer...
The Wheel Rim Clamp # 15-2 that you referenced will install with the lip towards the inside of the hub on the other side of the nut that holds it in place. The angled portion of the clamp sits outside of the wheel and it will tighten up against it as you turn the nut.
We don't have any pictures available of this particular clamp installed and it's a little hard to describe it but if you search for some images online of a wheel rim clamp installed you might get a clearer picture as to... view full answer...
You can indeed install a brake controller on a 2000 Cadillac DeVille.
As a first step, you'll need to access the taillight wiring circuits. The best and safest way to do this would be to use a powered taillight converter like # C59496. You could directly wire into the taillight circuits using a wiring kit like # 18252, but you'd lose the circuit protection offered by the taillight converter. The converter would protect the electronics in your vehicle from any short circuits that might... view full answer...
Go To Results