For the 2012 Chevy Cruze it looks like there are base plates for various models. If your 2LT does not have fog lights and is not an RS model then I recommend the Roadmaster base plates # 523168-1. If you have an Eco model with active air shutter system, go with # 523170-1. And for an RS model the only option is # BX1698.
For either of the Roadmaster base plates I recommend the Falcon 2 tow bar # RM-520. If you need the Blue Ox base plates then go with the Avail tow bar # BX7420. For safety... view full answer...
It sounds like you already have a roof rack with round crossbars for your 2018 Chevy Cruze; your Sears X-Cargo Sport 20 cargo box will mount directly to those with the standard mounting hardware. If you need to replace the standard mounting hardware you can use the Replacement Hardware Kit for Searsbox Cargo Box # TH05603, which will allow you to mount your box to the round bars. view full answer...
The straps used in the video are Rhino-Rack Anchor Strap # RRRBAS. The strap sits under the hood and trunk of your 2016 Chevrolet Cruz. The foam covered anchor sits under the hood and trunk and are held in place once the hood and trunk are securely closed.
The Rhino-Rack anchors are packaged individually. Therefore, you will need two for your vehicle. view full answer...
For your 2018 Chevrolet Cruze, I recommend checking out the:
-20x47 Reese Cargo Carrier for 1-1/4" Hitches - Steel # 63155.
This is a cargo carrier measures 49-1/2" long x 21-1/2" wide x 5-1/2" tall, has a maximum weight capacity of 300-lbs, and will fit into any class I and class II trailer hitch.
As far as a ramp also being available, that is not going to be an option, unfortunately.
Finally, if you're also needing a trailer hitch for your Cruze, I recommend the Draw-Tite Sportframe... view full answer...
The best way to carry 3 bikes on your 2018 Chevy Cruze Hatchback and keep access to your rear hatch without removing the bikes or bike rack is to either use a hitch mount bike rack for 2 bikes and a roof mount rack for the 3rd or to carry all three bikes on the roof. These 2 options will require more of an investment than a trunk mount bike rack, but they are your best and safest options.
Unfortunately, there are no trunk mount bike racks that will fit the hatchback models at this time... view full answer...
First you will need either the Roadmaster Base Plate # 523170-1 if you have an eco trim on your 2011 Chevrolet Cruze or a Roadmaster Base Plate # 523168-1 for all other trim levels. To connect your Roadmaster Falcon All Terrain, Non-Binding Tow Bar # RM-522 you will need a Quick Disconnect Crossbar Assembly # 910021-00 as the mounting systems for your Cruze require a crossbar.
For the tail light wiring you will need the Roadmaster Universal Hy-Power Diode Wiring Kit # RM-152 and a 6-Wire... view full answer...
Since fuses need to be pulled with your 2011 Chevrolet Cruze, you are correct that a fuse bypass would be needed, and for that you would want Roadmaster FuseMaster Fuse Bypass # RM76511. The simplest lighting option would be the Hopkins Magnetic Tow Lights # C6304. view full answer...
I took a look at the owner's manual for your 2017 Chevy Cruze and on page 261 it states "The vehicle is neither designed nor intended to tow a trailer" so I cannot recommend you do so, though the decision is of course up to you. If you do decide to tow, then you will absolutely want to go with the lightest, smallest of the trailers.
For a diesel model of '17 Cruze the available trailer hitch from Curt is part # C11492, and since you mentioned 2" ball I assume you are also using the Euro... view full answer...
The best source for this type of information is going to be your vehicle's owners manual, especially since there is some conflicting information. From what I was able to find, the 2015 Chevy Cruze Diesel has a towing capacity of up to 1000-lbs, which may or may not be enough to tow a small camper. You can find out the dry weight of your camper by checking the spec sticker, which should be located somewhere on the trailer tongue or the body of the camper. I would also recommend consulting... view full answer...
I'm assuming you're needing an adapter that would allow you to use an accessory for a 2 inch hitch in the 1-1/4 inch Draw-Tite # 24882 on your Chevy Cruze. We offer 2 adapters that are compatible with a Class I hitch like what you have. The CR Brophy # HT5R would provide a 5 inch rise for additional ground clearance and their # HTAD is a straight adapter. Using either adapter will reduce the 200 lb tongue weight (maximum amount of downward force that can safely be applied to the hitch)... view full answer...
If your F-450-based motorhome needs an upgrade from 4-pole flat wiring to a 7-way setup so you can send brake power to your tow dolly you can use 7-way install kit # ETBC7 which includes the 7-way adapter as well as the wiring, connectors and other parts needed to wire a brake controller like the Prodigy P3 # 90195. Your existing 4-pole plugs into the adapter's mating plug for the basic light signals and you'll make three other circuit connections to add auxiliary 12V power, brake power... view full answer...
Go To Results