bing tracking image

Filter Questions and Answers:

reset filter

Expert Answers about Kia Borrego


  • Are There Fuses Under Hood of 2009 Kia Borrego Needed to be Installed for Brake Controller
  • Yes you do need to install some fuses under the hood of your 2009 Kia Borrego to install the Prodigy P3 part # 90195 with the part # 3032-P. Check the owners manual for brake controller power circuit fuses and insert them into the slots that are missing them.
    view full answer...

  • Recommended Trailer Wiring Harness and Ball Mount for 2009 Kia Borrego
  • Starting with the trailer wiring harness, if your Kia Borrego is equipped with the factory 7-Way connector, the Curt T-Connector Vehicle Wiring Harness # C55384 that you referenced is the correct part. This custom harness will plug right into the built-in harness located behind the rear bumper. You will simply plug the harness in-line with the existing 7-Way. This will provide you with a 4-Way connector that will connect with and power your utility trailer's basic signal lights. Otherwise,...
    view full answer...

  • Engine Block Heater for 2009 Kia Borrego
  • I wasn't able to find the location of a factory block heater cord on your 2009 Kia Borrego. If you weren't able to find anything in the areas you checked then your vehicle might not be equipped with one. You can verify this by checking with a local Kia dealer and providing them with your VIN. With this information they should be able to tell you exactly what the vehicle is equipped with and the location of the cord if present. If you do not have an engine block heater then the Kat's Heaters...
    view full answer...

  • Where Do Each of the Wires of the Tekonsha Breakaway System part # 50-85-313 Run
  • The three wires of the Tekonsha Breakaway System part # 50-85-313 will get wired as follows: The white wire attaches to the ground wire. The blue wire attaches to the brake output circuit that goes to the brake assemblies of the trailer. The black wire runs to the 12 volt power source of the 7-way.
    view full answer...

  • Recommended Weight Distribution And Front Of Trailer Bike Rack For Jayco Swift SLX 184BH Trailer
  • Based on the information you gave, the Reese Strait-Line Weight Distribution w Sway Control - Trunnion Bar - 10,000 lbs GTW, 600 lbs TW # RP66072 will be an excellent system for a total tongue weight between 200 and 600 lbs. The total tongue weight is your loaded trailer tongue weight along with any cargo weight behind the rear axle of your tow vehicle. This is my favorite weight distribution system because it constantly fights against sway with the dual cam system versus sliding with...
    view full answer...