If you had a small trailer for your motorcycle you could tow it with your 2013 Dodge Avenger with the Curt hitch part # C11133 installed but if you were thinking about using a motorcycle carrier there's no safe way to do this with your Avenger.
For trailer wiring you'd then want the part # C56211 which installs pretty easily.
Then for a ball mount part # C45522 and hitch ball # C40001. view full answer...
Proportional controllers will return to a minimum braking power if the brakes have been applied for an extended amount of time. Also, once the controller no longer senses deceleration it will stop sending the max amount of brake power to the trailer axle.
That's the nature of proportional brake controllers. They try to match the same amount of braking action that the tow vehicle is applying. view full answer...
For your 2009 Dodge Avenger, there is not a class III or IV hitch available. Your best option is the Draw-Tite Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4" # 36448 which is rated for 3500 lbs. To get your 2 inch receiver you will use the adapter which will reduce the 300 lb capacity of your hitch to 150 lbs which also includes the aluminum carrier weight. For the adapter I recommend the Brophy Trailer Hitch Receiver Adapter # HT5R. It has a 5" rise to give you greater ground... view full answer...
For your 2014 Dodge Avenger R/T there are only Class I hitches available. Which as you have already determined means that you cannot carry more than 2 bikes on a rack installed in the hitch.
One way around this is to use a 3-bike trunk mounted rack like the Thule OutWay part # TH56BV. This rack has been confirmed as a fit for your vehicle and will allow you to carry up to 3 bikes.
If you plan on carrying any women's or alternative framed bikes without horizontal top tubes you may also... view full answer...
The bike rack I recommend for your 2013 Avenger is the Thule OutWay, part # TH45JV.
This bike rack has the patented fit dial to make sure you get a great fit on your vehicle. This bike rack features anti-sway cradles to help keep the bikes from banging into each other and also features a locking cable to secure the bikes on the rack along with locking covers over the release levers that secures the bike rack to the car. This bike rack uses only two retractable cables to hold the rack... view full answer...
The trunk mount bike rack that I would recommend for your 2013 Dodge Avenger SXT with the rear spoiler is the Hollywood Racks Expedition 2 Bike Rack, # HRF6-2. This bike rack was designed with a longer lower support arm to clear factory spoilers. I have attached a demonstration video of this bike rack on a 2014 Dodge Avenger for you to check out. This car does not have the spoiler, you can use the fit of the bike rack to see that it will clear the spoiler.
If you will be carrying any... view full answer...
The Rhno-Rack legs that fit your 2008 Dodge Avenger are the 2500 Series Legs # RRRLKVA.
To complete the roof rack you need crossbars # RRVA126B-2, and fit kit # DK046 to install on your Avenger.
The Rapid Traverse foot pack # TH480R, will require AeroBlade bars # THARB53 , and fit kit # THKIT1539.
The Vortex aero bars are much quieter and aerodynamic than square bars. Plus they look a whole lot better than the square bars, more OEM, in my opinion.
I've linked a video of the system... view full answer...
Go To Results