Installing a roof rack on your 2013 Hyundai Accent Hatchback is actually pretty straightforward as the legs mount to specific points on your roof using some bolts. I recommend using the Rhino-Rack Vortex roof rack which uses the following parts:
46" Vortex Aero Crossbars - # RRVA118B-2
2500 Series Legs - # RRRLKVA
Fit Kit - # DK289
The Inno Board Locker Surfboard Carrier # INA744 will fit this roof rack and give you a way to transport your surfboards but I did see that your antenna sits... view full answer...
I have a hitch that will fit your Accent hatchback but the item # 24760 only fits the sedan models. Instead you will want the Curt Trailer Hitch item # C11092. This hitch is custom fit for the hatchback models and bolts to your car with included hardware.
I really like the Curt hitch because it is made in the USA. This is a class I hitch with a 1-1/4" receiver. It has a 2,000 lbs towing capacity, and a 200 lbs maximum tongue weight. It weighs only 23 lbs.
If you are planning on towing... view full answer...
I do have a solution for you but that Curt hitch receiver item # C11548 is not compatible with your 2020 Subaru Ascent hatchback.
I recommend a different Curt hitch receiver item # C25VR. This receiver is designed specifically to bolt onto your vehicle without any cutting or drilling. This receiver is a higher strength one than the 1-14" receiver you had previously looked at. It has a 5000 lbs towing capacity and a max tongue weight of 750 lbs. The Curt receivers for your Ascent only come... view full answer...
The Draw-Tite Sportframe Trailer Hitch, # 24884, will fit on the 2012 Hyundai Accent 5 door hatch back, which is 4 side doors and the 5th door being the hatchback door itself. I attached installation instructions for you to review.
The manufacturers gross trailer weight rating for this hitch is 2,000 lbs and the gross tongue weight rating for this hitch is 200 lbs.
If you will be using this hitch for towing a trailer you will also need a trailer wiring harness, # 119178KIT, instructions... view full answer...
Yes, Draw-Tite trailer hitch # 24795 will fit the hatchback models of the 2008 Hyundai Accent. We list it as fitting the sedan and 3-Door hatchback because the rear hatch is being counted as a door. I have included a link to the installation instructions and a link showing a typical installation on a similar vehicle for you.
If you plan on doing some towing, the correct ball mount is # 3594 and you can use pin and clip # PC2. For a 1-7/8 inch diameter ball use # 19256 and for a 2 inch... view full answer...
The SportRack Semi-Custom Roof Rack for Naked Roofs, # SR1002, will fit on a four-door 2010 Hyundai Accent. The rack will also be able to carry a 15-foot canoe as long as the watercraft weighs no more than 105 lbs, which is the rack's weight limit for your vehicle based on the manufacturer's fit guide, which I have included a link to.
I also recommend the Thule Portage Canoe Carrier, # TH819, which comes with four cushioned brackets and the necessary tie-down straps to strongly secure... view full answer...
On the Thule AeroBlade crossbars the upper part of the T-slot is 1/2 inch wide and the lower part is 3/4 inches wide. T-bolt # 853-0782 could work. The threaded part is 2 inches long and has a diameter of 8 millimeters.
3-wing knob # 753-0776 is an M8 and is a potential candidate for this use. But none of these parts have been tested together so I cannot say how well the Thule parts will work with the Yakima parts so it is an -at-your-own-risk type of situation. view full answer...
Hopkins Tail Light Converter Kit # HM48925 can be used on pretty much any vehicle since it is a hardwire kit. The 2008 Hyundai Accent (sedan and hatchback models) are represented in the list of fits though because it is such a big list it is easy to miss it. view full answer...
While we do have a hitch that fits your 2022 Hyundai Accent, your current hitch does not fit, and the reason for that is the Accent underwent a generation change in 2017, so it was redesigned with different frame spacing and mounting.
So for a hitch that does fit your '22 Accent so you can use your bike rack, what you will need is the following from Curt:
- Curt Trailer Hitch Receiver # C11548 view full answer...
The 2005 and 2006 model years of the Hyundai Accent do not accept the same base plate kits. The 2005s can use either Blue Ox # BX2316 or Roadmaster # 1616-1 while the 2006s that have a manual transmission and no fog lights can use the Blue Ox # BX2323 that you referenced or Roadmaster # 1623-1.
Base plates are one of the components needed for safe and legal flat towing. The others are a tow bar, safety cables, a wiring/lighting solution and a supplementary braking system for the towed... view full answer...
The Yakima HangOut 3 Bike Rack, part # Y02638, is listed as a fit for the 2012 Hyundai Accent Hatchback, but Yakima does not test the bike rack to fit a vehicle with a spoiler. The top hooks on the bike rack need to hook on to the top of the vehicle's hatch lid. The straps on the bike rack should not be against the spoiler, otherwise, the spoiler could be damaged when the straps are tightened down. If the spoiler has openings that the straps can go through and allow the bike rack to be... view full answer...
The only hitches available for a 2013 Hyundai Accent Hatchback are Class I, 1-1/4 inch receivers such as the Draw-Tite # 24884, while the Rhino Rack T-Load Assist Bar RRRTL001 is a Class III item and would be incompatible with any of the hitches that fit your Accent.
If you are interested in load assist, you have some options, and I recommend checking out the Inno Kayak Lifter # INA453 or for a load assist and carrier in one, the Yakima Kayak Carrier with Tie-Downs - Saddle Style with... view full answer...
All of the trailer hitches for the 2009 Hyundai Accent hatchback are Class I trailer hitches with a 1-1/4 inch receiver. The Swagman XTC, # S64670, does fit Class I trailer hitches. The rack measures 8 inches from the center of the hitch pin hole to the closest edge of the first wheel hoop. This should be enough to clear the back of your 2009 Accent. I have included a link to a help article that explains how to measure for clearance. I have also linked a video showing the rack on a 2013 Accent. view full answer...
I spoke with my contact at Curt about your 2014 Hyundai Accent Hatchback. They told me that they have not verified a fit for the plug-in harness, part # C56149, you referenced, but they said it would probably be a fit.
They did say that part # C56175 would work for your Accent. It is a non-powered harness and does require hardwiring into the vehicle wiring. This has a protected circuit module and will give you a 4-way connector at the rear of your vehicle. The installation instructions... view full answer...
The Saris Solo Bike Carrier # SA102 is confirmed to fit your 2017 Hyundai Accent 5-Door Hatchback but at this time we do not have any photos of it installed on that specific vehicle.
Attached is a review video to give you an example of how this bike rack installs. I'm also attaching a link to the installation instructions for you to check out. view full answer...
There is only one option for a roof rack for your 2010 Hyundai Accent hatchback, which is the SeaSucker Monkey Bars Roof Rack # 298-SX6000B.
There are no traditional-style roof racks for your '10 Accent but the SeaSucker will function exactly the same, with the difference being it attaches via its vacuum cups instead of clips. I have added a link below to a video review to check out as well. view full answer...
The Draw-Tite Sportframe Trailer Hitch Receiver part # 24795 fits the following vehicles:
2007 - 2011 Hyundai Accent 3 Door Hatchback
2006 - 2011 Kia Rio 5 Hatchback
2007 - 2010 Hyundai Elantra Sedan
Please let me know your year make and model if it's not on the list and I can recommend a hitch that fits. I have added an installation video on a 2010 Hyundai Elantra. view full answer...
Your 2012 Hyundai Accent GLS sedan can absolutely use the Malone trunk-mount bike rack you mentioned, which is the following part number:
- Malone Runway Trunk Bike Rack for 2 Bikes # MAL84RR
The only other thing you may need, if one of your mountain bikes has a step-through frame, is an adapter bar to give the bike a horizontal mounting point; for that you will need the Hollywood Racks Bike Frame Adapter Bar # HRBA-PRO. view full answer...
The Tow Doctor for the trailer side is # HM50928. The other one, # HM50918, is the vehicle side.
For the trailer side model it does not work if the trailer has LED lights. LED lights draw too little power for the tester to work properly.
You could test the trailer side by using a separate 12 volt wire and applying power to each function. If the function does not work doing this test you know there is a wiring issue. view full answer...
The Yakima LoadWarrior basket, # Y07070, comes with mounting hardware that will fit crossbars up to 3-1/4 inches wide. The Rola roof racks use elliptical bars that are 3-1/8 inches wide so the Yakima mounting hardware will fit. view full answer...
Go To Results