Expert Answers about GMC Acadia

• What is the Maximum Amperage Draw Rating for a 7-Way Trailer Connector
• The reverse light circuit on most vehicles usually have a max amperage draw of around 5 amps. The amperage is usually limited by the gauge of the wire used on the circuit. The recommended wire size for the reverse light pin on the Pollak Black Plastic, 7-Pole part # PK12-707E is a 14 gauge wire. The maximum amperage that can be ran through a 14 gauge wire safely is 15 amps.
  view full answer...


• How to Tow 2017 GMC Acadia With 2.5L Engine
• There is a way for you to tow your 2017 GMC Acadia, but the reason that base plates like the Roadmaster # RM-523189-4 will not work for you is because according to the owner's manual, a '17 Acadia with a 2.5L engine cannot be flat towed. In order for you to tow your Acadia you will need a tow dolly, and I highly recommend the Demco Kar Kaddy X Tow Dolly with Disc Brakes - Tilt Bed Frame # DM9713093 or Demco Kar Kaddy SS Tow Dolly with Disc Brakes - Foldable # DM9713045 because these are...
  view full answer...


• Where Do I Install A Trailer Wiring Harness On My 2014 GMC Acadia
• It sounds like you are definitely on the right track. On a 2014 GMC Acadia The plug for the wiring harness # C56245 should be behind a trim panel behind the passenger side wheel. Sometimes locating these plugs can be tricky, and vehicle manufacturers do not make it easy. It is recommended to remove the rear passenger side tire to free up some space to work. You will need to remove a few screws from the wheel well trim panel to access the connector. Even if your vehicle does not have any...
  view full answer...


• Can you Keep the Same Lock and Key Numbers with the Thule T2 2-Bike Expansion Accessory
• This rack comes with locks for both the carrier and the bikes. and they are all keyed alike. The Thule T2 Pro XTR Bike Rack, # TH69TX, kit can be set up to carry 2 or 4 bikes as needed.
  view full answer...


• Does Hitch Ball Come Installed On Draw-Tite Ball Mount
• The Ball Mount, part # D-4 does not come with the hitch ball installed. The 2-inch hitch ball I recommend is the Tow Ready, part # 63845. You will also need the Hitch Pin and Clip, # PC3. When installing the hitch ball it needs a torque rating of 250-lbs and requires a 1-7/8 inch socket. If you do not have a torque wrench most local auto parts or mechanic shops have them and may be willing to lend it to you or even tighten the ball themselves.
  view full answer...