The Jensen RV Stereo part # JWM70A does not need to be set to DISC mode to play a CD. If you place the CD into the slot label side up the stereo will play the CD automatically. The CD mode is not activated until there is a CD in the stereo. If you place the CD in the stereo and it just says "loading" then it needs to be replaced under warranty according to Jensen. view full answer...
From What I could find out, it looks like your 2021 Arctic Fox 29-5T came with a MORryde RPB King Pin, but I couldn't confirm which specific pin box it is mated to. What you will need to do is contact Northwood directly with your VIN. They will be able to tell you exactly which pin box you have and this is the easiest way to go about finding it.
In the off chance they cannot tell you, there are other ways to verify which one you have. First will be to check your pin box for a label. The... view full answer...
The MaxxAir FanMate RV and Trailer Roof Vent Cover - 25" x 18-1/8" x 10-1/4" # MA00-955003 is designed to fit 14" x 14" vents so you'll have no issues installing it on your Fan-Tastic Vent Roof Vent w/ 12V Fan and Remote # FV807350. this roof vent cover for your RV or camper enables you to open the vent and operate the fan in any weather. It allows air to circulate at all times, even when you're away or sleeping to prevent heat buildup while also keeping rainwater from entering and damaging... view full answer...
The Dexter D52 Nev-R-Lube Axle uses 42mm bearing cartridges according to my research so the Dexter Disc Brake Kit part # K71-647-648 will fit just fine. view full answer...
The Thule EasyFold XT # TH903202 is a great bike rack for e-bikes but it unfortunately doesn't have the strength to handle the extra movement at the back of a travel trailer. Because of this you're going to need to install a different hitch receiver on your trailer, like the Curt # E-100 for a 4" x 4" bumper, and then use a bike rack that is a bit more rugged and can handle that movement.
For your application I recommend going with the Swagman E-Spec Bike Rack # S94FR which is a bit more... view full answer...
If you haven't already you'll want to pull the pins that connect head of your B&W Companion # BWRVK3600 to the base. From there you'll be able to lift the head off of the pivot arms by pulling up on the handles with rubber grips on each side of the hitch.
If not, then your hitch might have some internal issue since the locking mechanism for the handles is not releasing and you'll want to reach out to B&W for a warranty claim.
The head only weighs approximately 70lbs so you should be... view full answer...
It really just depends on if the light has bulb style LED light bulb or if it's hardwired into the casing. If it's a simple bulb like part # DI86VR you could pull it out and replace it. The # DI86VR is designed to replace 194, 906, and 921 bulbs. If the LED panel is hardwired like the Optronics 12V LED RV Dome Light # RVILL33 you were looking at then you'd have to replace the entire light. view full answer...
In order to find the correct replacement leaf springs for a trailer you'll need to know the type (slipper/double eye), weight capacity, and unloaded length. The springs will stretch over time so the new replacements will be shorter. If you have a 3,500 lb axle with double eye springs then you'll likely need 3-Leaf Double-Eye Spring part # e59SR which measure 23-1/8" long. view full answer...
The shipping weight for the Adco Olefin HD RV Cover for Travel Trailers # AD67ZR is 27lbs so the actual weight without packaging is approximately 25-26lbs. If you and another person set up ladders you could pull the cover over the top of the trailer without actually having to get on the roof. AJ did a bit of both since he was working alone, but he does offer some helpful tips in the attached video below. view full answer...
Yes the Adco Polypropylene Storage Lot RV Cover for Travel Trailer # 290-74845 will fit your toy hauler that has a height of 110 inches when the measurement includes the AC unit. The recommended place to measure height is the box height without including the height of the AC unit. view full answer...
The SumoSprings Trailer Helper Springs # SS26MV are the correct size for your 2016 Northwood Artic Fox 29.5. You will need to ensure you have between 5-5/16" - 6-1/2" between your frame and leaf spring plates. The leaf spring plate must also be no wider than 4-1/4" to ensure the mounting bracket will fit. If your Artic Fox meets these criteria you will need 2 of these kits for your tandem axles. view full answer...
The multitude of bolt patterns and tire sizes used on each trailer prevents us from having a specific for each trailer. If a previous owner or a dealer changed the axles and thus the bolt pattern we wouldn't want to recommend something that wouldn't fit.
To get the right fit for your 2021 Northwood Arctic Fox Grande Ronde Fifth Wheel Trailer you'll need to know the bolt pattern for the wheel and the tire size for the tire to ensure you don't change the ride of your trailer. I've attached... view full answer...
The manufacturers of RV and trailer covers now are designing most covers to be used with rooftop AC units, since they're almost standard equipment these days; I suspect the cargo rack is shorter than or the same height as the AC unit, so this shouldn't affect the fit of the cover.
With that said, I wasn't able to locate the exact dimensions of a 2004 Arctic Fox 1150 but previous models I've seen are around 19 feet long. For this reason the Camco UltraGuard Slide-In Camper Cover - 19-1/2'... view full answer...
Yes. You will be able to use these Brass Tire Sensors for TireMinder # TM-2BRASS with your TM66. From what I was able to find out, the TM66 system is the same system as the Tire Minder TPMS for RVs # TM-A1A-4 and # TM-A1A-6 ; the only difference is that the A1A systems came with a larger LCD screen. The TM-2BRASS will work with all brass and steel valve stems. If you have aluminum valve stems you can use part # TM-2ALUM as a replacement. view full answer...
Yep, per Dexter, the OEM brake controller on your Ford F-250 is compatible with Dexter's EOH actuator. The correct actuator will depend on if you are using disc brakes or drum brakes:
- Disc: Dexter DX Series Electric Over Hydraulic Brake Actuator # K71-651
- Drum: Dexter DX Series Electric Over Hydraulic Brake Actuator # K71-650 view full answer...
Yes, the Replacement Controlled Motion Hinge for RV Entry Door is offered in both black as part # LC95VR and white as part # LC22NJ. view full answer...
I spoke with Lippert and their tech said most awning rails are a standardized size and that you shouldn't have any issues installing your # LCV000184673. If for some reason your C Channel is giving you too much trouble the # LCV000184673 kit comes with a J Channel you can easily install with a few screws. I recommend using Butyl Tape # 344270341410-1 to protect against any water damage. view full answer...
The Adco Olefin HD All-Climate + Wind RV Cover for Travel Trailer - Up to 31-1/2' Long # AD27ZR is what you need for your 2020 Northwood Arctic Fox 25Y. The cover says it measures 104" wide and while that's true, the width of these covers does accommodate for extra things like an awning and/or downspout. So this is designed for a 104" wide box but it will fit with the extra things you have on your trailer. You'll just have to be a little extra careful when sliding the cover over those parts... view full answer...
Yes, the Jensen TV mount part # MAF50 will work with the Jensen TV part # JTV32DC that you also mentioned. This mount has a 40 lb weight capacity and the TV weighs 10 lbs so it would easily handle it. The 100 dimension you mentioned is same between the two. view full answer...
The Swagman Traveler # S64663 Bike Rack is approved to go on not only your truck and car, but also your 2019 Arctic Fox Fifth Wheel. view full answer...