For your motorhome built on a 2018 Ford F-53 chassis that has a GVWR of 24,000 lbs the correct rear sway bar is the part # RM-1139-149 and not the # RM-1139-148 that you ordered unfortunately. This is why you are experiencing the issues you are. view full answer...
Yes, you can install the Roadmaster Diode Kit part # RM-154 on your 2017 Toyota Yaris so that you can operate the taillights of the vehicle while it's on the tow dolly. You'll need an additional 4-way though to activate these lights and the lights of your dolly. For that the # C55384 will install in line with your current 7-way wiring and will allow the 7-way to be active as well as the 4-way. view full answer...
If you are sure the power source is 6 volt the part # RVIL21 would not work for you. This is a 12 volt only light and we don't have any similar 6 volt options. I would double check though as I would be shocked if your motorhome was 6 volt. view full answer...
I really wish we had replacement arms/boots for the Blue Ox Avail but they do not offer them as a replacement part so your best option would be a new tow bar with the # BX7420. view full answer...
For your 2004 Newmar Dutch Star Class A motorhome you can use one of the 2-inch RV-rated trailer hitches shown on the linked page.
We offer both bumper-mount and frame-mount hitches and the better option is usually the frame-mounted type like # C13701 since these can provide higher weight capacities than many RV bumpers allow. This hitch fits RV frame widths from 18- to 51-inches and it has a receiver tube with 2-inches of drop, which can help the receiver clear trim/fascia components... view full answer...
For your 2014 Newmar Bay Star Sport MH I recommend going with the Roadmaster Rear Anti-Sway Bar # RM-1139-145 first if you have to choose.
Since your coach is rear-wheel drive you'd benefit most from an anti-sway bar for the rear. Obviously adding the front anti-say bar would only further improve handling, but if you need one now and can't get both, the rear is what I'd do first. view full answer...
I may have a solution for you but there are no custom fit front mount trailer hitches available for the 2011-2012 ford F-53 Chassis. The Curt Adjustable Width Trailer Hitch Receiver for RVs part # C13702 or the Curt Adjustable Width 2" drop Trailer Hitch Receiver for RVs part # C13701 would be the options to check out.
I do not have specific data for the overhang you have past the frame on your 2012 Newmar Canyon Star but these would be the only options I have that would come close to... view full answer...
I'd recommend going with air springs like the Air Lift LoadLifter kit part # AL57344 which is a confirmed fit for your 2012 Newmar Canyon Star Motorhome 3642. This will give you the support you need and even can allow you to easily tailor the amount of support you get on either side of the motorhome to level it side to side. view full answer...
I really like the Redarc Tow Pro Liberty part # RED52VR as it's proportional like you mentioned, is compatible with vehicles that have air brakes, and it only puts a small knob on the dash of the vehicle. view full answer...
I recommend adding jounce springs to the rear of your vehicle to reduce body roll and rear sag, along with improving the overall handling of the vehicle. I also recommend installing the front steering stabilizer to help keep the vehicle straight and handling properly. Typically you would not need to also install front jounce springs unless you always have a lot of weight at the front of the vehicle for any reason; I also don't think you would need the rear stabilizer bar since the jounce... view full answer...
We have the Global Link Ultra E Pro Lock part # 295-000183 like it sounds like you are looking for. This fits the standard travel trailer lock cut out of 3-3/4" tall x 2-3/4" wide. view full answer...
The Propane Tank Connector Fitting # 37207-30075 has a excess flow limit feature built into it that limits flow if there was to be a leak whereas the # 37207-30065 does not have that feature. Aside from that they are the same and have a soft nose POL on one end and a 1/4 inch male NPT on other. view full answer...
For aluminum sensors to use with the TireMinder i10 TPMS for RVs # TM56FR the part # TM-2ALUM would be what you'd need for a pair of these sensors. These are needed for if your valve stems are aluminum like it sounds like they are. view full answer...
Since you said you can use a Solera awning tube and yours is 19 foot 6 inches long the correct replacement roller would be the part # LC33FR. view full answer...
For the front you would want the SumoSprings part # SSF-170-40-2 and for the rear # SSR-187-54-1 and you'd be set. We've installed these on a similar Newmar Bay Star Sport 2813 as yours and we found they fit and worked great. view full answer...
We do have a tray that'll fit your Dometic CFX3 95DZ, but the MORryde # MR69UR has an internal measurement of 35-1/2" where you fridge say its just over that at 35.52". That's way too close for me to be able to confirm it's going to fit.
Instead you'll need to go with the larger # MR59FR which has an internal measurement of 46-1/4" long x 25-7/8" wide so you'll have zero fitment issues. view full answer...
The 2013 Newmar Canyon Star Motorhome that is built on the Ford F-53 chassis, will use the Roadmaster Exact Center Steering Stabilizer with Custom Brackets for Ford F-53 Chassis, # RM36RR. view full answer...
I have a solution for you.
Rock Tamers Heavy-Duty, Adjustable Mud Flap System for 2" Hitches - Matte Black # ERT00108.
Rock Screen for Rock Tamers Heavy-Duty Adjustable Mud Flap System # RT37FR.
We do not have custom fit rock tamers with cut outs for mufflers. However we do have the Rock Tamer Heavy-Duty system. It can expand up to 96 inches and is 24 inches tall.
You can pair it with the Rock Screen for optimal protection from road debris that can be kicked up by your RV.
Make sure... view full answer...