Your pair of 55 lb ebikes are absolutely within the capabilities of the Roadmaster Spare Tire Carrier # RM-195125.
The receiver portion of the Roadmaster # RM-195125 has a tongue weight capacity of 200 lbs, so the 110 lb combined weight of your ebikes and the weight of a a motorhome-approved rack such as the 52 lb Thule T2 Pro XTR Bike Rack # TH83JV or 54 lb Hollywood Racks Sport Rider SE Bike Rack # HLY84FR is still going to be well under 200 lbs.
This carrier is going to be the perfect... view full answer...
Per the instructions, the smallest diameter pan/pot that can fit on the burner of the Cadac Safari Chef 30 Compact Butane-Propane Grill, Griddle, and Stove # FR99WJ is 7 inches.
Additionally, the largest diameter pan/pot that can fit the # FR99WJ is 10 inches. view full answer...
The etrailer # e98842 hitch is 35-1/2" wide when measured from bolt hole to bolt hole; this is going to be the most important measurement for this hitch since it will determine the overall fit. The bolt holes on the frame are 2.43" center on center and 6.13" center on center. You should be able to use these to determine if your bolt holes will line up or if you will need to drill new holes to make this work. view full answer...
When the MaxxFan Plus Roof Vent w/ 12V Fan, Thermostat, and Remote # MA00-04500K is closed it would add 3-3/4 inches to the roof of your RV and when open it would add 12-1/2 inches. view full answer...
The Westin HDX Grille Guard item # W88XV you were looking at will block sensors that it covers on your 2023 Ford Transit. I don't have a Ford Transit in front of me but I do own a similar grille guard for my truck. Basically anything above the bumper will be behind the guard. Bumper sensors will be be ok unless they're around the center where the grille guard attaches.
I have linked the instructions below so you can get an idea of what if any sensors will be blinded. Westin has some great... view full answer...
I checked with Curt and was able to find a couple of diagrams of the mounting bracket and the receiver portion for the Adjustable Width Trailer Hitch Receiver item # C13702. I have attached them below. The width is adjustable between 22" and 72".
I have linked an installation video below so you can see how to get this hitch set up. view full answer...
Unfortunately, we don't have any additional photos of the Malone Cargo Box # MPG902 that shows the mounting hardware as of yet but I can tell you the mounting points are adjustable. They're on tracks that can be spread apart from each other from 25 to 40 inches front to back. view full answer...
The Hollywood Racks Trail Rider part # HR200Z does have a 45 lb per bike capacity as we have confirmed this with Hollywood Racks.
I attached a review video for this bike for you to check out as well. view full answer...
The GearSpace 34 cargo carrier will work for you, but as for opening the rear doors you will need to verify with some measurements. It should based on customer feedback, but we haven't test fit it ourselves; I did add a cut out of a review a customer with a Beyond motorhome sent us so you can see what I'm referencing.
When extended, the GearSpace measures 31 inches to the closest edge of the carrier, so just measure 31 inches from the center of the hitch pin hole and compare that to how... view full answer...
The High Pointe RV Convection Microwave # HP99ZR has a maximum power input of 1,500 watts in both microwave and convection mode. The 1,000 watt rating is the output cooking power provided in microwave mode. view full answer...
The distance from the floor that the MORryde Sliding Tray for RV Cargo Compartment # MR39FR is mounted on to the carpeted surface of the tray is approximately 1.75" view full answer...
The distance between the mounting holes for the etrailer hitch part # e98842 that fits your 2020 Ford Transit T350 is 35-1/2 inches from left to right and the bolt holes on the frame rail are 2.43" center on center and 6.13" center on center. view full answer...
In regards to the etrailer Trailer Hitch Receiver part # e98842, the distance between the bolt holes left to right is 35-1/2" on center which you can see in the attached photo below. view full answer...
The VanTred Custom Floor Mat # VTFT15L is a 1/2 inch thick. I verified with Bedrug that the entire mat consists of the foam and the thermoplastic is just a thin layer covering the foam to create a flat surface. view full answer...
The etrailer.com Trailer Hitch Receiver # E98842 that fits a 2017 Ford Transit T350 has arms that are spaced 35-1/2 inches apart from center to center.
The bolt holes on the arms of the hitch measure 6-1/8 inches center to center for the two furthest apart bolt holes and 2-3/8 inches from center for the shortest apart bolt holes.
I have added a link to an installation video of this hitch for you to take a look at. view full answer...
The Round A-Frame Trailer Jack # TJA-5000S-B has mounting holes that are elongated. The actual holes are 3/4 inch long and 7/16 inch wide. That gives you a minimum of 2-1/2 inches or maximum of 3-3/4 inches to the nearest or farthest part for mounting. I've attached a photo to assist. view full answer...