12-3/4" Wide x 7-5/8" tall x 3-1/2" deep, remote cooler assembly improves the performance and functioning of your transmission, power steering or fuel system. High-flow tornado fan supplies air for the 6-pass, tube-fin heat exchanger.
Features:
Specs:
Perhaps the simplest type of heat exchanger, the tube-fin effectively cools a variety of automotive systems. The concept is simple: Fluid cools as it travels through the core by transferring heat out to the fins. The fins then provide the surface area necessary for sufficient heat exchange to take place, allowing the heat pulled from the fluid to dissipate into the surrounding air. Quick, easy and effective.
Take it a step further with a fan-mounted unit and you can be sure that there will always be optimum airflow for your tube-fin cooler no matter where it is mounted or what sort of environment you are traveling through, making it perfect for those hot days spent sitting in traffic.
Average Customer Rating: 4.3 out of 5 stars (3 Customer Reviews)
12-3/4" Wide x 7-5/8" tall x 3-1/2" deep, remote cooler assembly improves the performance and functioning of your transmission, power steering or fuel system. High-flow tornado fan supplies air for the 6-pass, tube-fin heat exchanger.I use this unit as a pre-cooler for my race transmission so that not so much heat transfers to my radiator. It works better than expected, and my tranny and engine run cooler. I consider this a small investment to help protect the much greater investment in my car.
This fan/cooler assembly seems to be good; however, in order to truly check it I will have to put a temperature gauge on the trani and oil lines to measure pre-cooling vs. post-cooling.
The cost to install will be higher because you must buy hoses and fittings, and you may need to buy oil-filter adapters.
It is a good size for my 2010 Town & Country (I could not use the larger, oil-alone or trans-alone coolers for this reason); I installed it near the left front wheel (but I needed to make a brace out of 2x6 wood for this).
Product was an easy install. Will fit in tight space. On bad thing I can say is the top three fitting are to close together. They need to be off set. I still would recommend it to others.
Do you have a question about this Transmission Cooler?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.