Replacement Frame Pin for Sno-Way 29 and 32 Series Snow Plows - 3/4" Diameter

Video Transcript for Review of SAM Snow Plow Parts - Snow Plow Replacement Parts - 3371303111

Today, we'll be taking a quick look at the replacement hitch pin with linch pin for Sno-Way Snowplow. This allows you to get that important component attached to your snowplow, so you can get back out on the road. It's going to be a handy thing to have, either on hand, in case this we're to fail, or just a direct replacement for that part that's already broken. Comes with the snap ring linch pin to keep that installed. It just goes around the end of our hitch pin and keeps it in place.The top of our hitch pin is coated with vinyl, sort of coating, to help give it a little bit of extra grip and make it a little bit easier on your hand as you're pulling that out or putting it in. Our hitch pin from the top of the handle to the bottom of the pin is about eight inches long, or just short of that.

About seven and seven-eighths. The width of the handle from outside to outside is about three and seven-eighths. The diameter of the pin is about three-quarters of an inch, and then the usable length there from the coating to that linch pin hole is about four and a half inches. From the coating to the very end of the pin is about five inches. The diameter on our linch pin is about a quarter inch, and that ring, snap ring, is about one and seven-eighths of an inch in diameter.This is made in the USA, and that's going to do it for our look at the replacement hitch pin and linch pin for the Sno-Way Snowplow..