Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
These feet let you mount 2 Inno square crossbars to your vehicle's rain gutters. Feet clamp onto rain gutters and tighten down with locking knobs built into the covers. Feet provide 9-7/8" of load bar clearance above your domed roof.
Features:
Specs:
Pair these feet with 2 Inno square crossbars (sold separately) to create an aftermarket roof rack for your vehicle with rain gutters. The feet clamp onto your rain gutters and tighten down with integrated hand knobs. The knob covers can be locked with keys to secure the system to your roof. And these extra-tall feet provide extended clearance for your vehicle with a domed roof.
The feet are easy to install with included tools. Loosely assemble the rack by removing the crossbar endcaps, sliding the feet onto your crossbars, and replacing the endcaps. Then set the rack on your roof with the feet resting in the rain gutters.
Slide the fit hooks and key plates onto the integrated bolts on the feet. Secure the fit hooks in place by threading the nuts over the bolts. Then tighten the nuts with the locking hand knobs.
Built-in width adjustment screws on the legs allow you to center the crossbars on your roof. Simply loosen the screws with the included hex wrench, adjust the bars as needed, and re-tighten the screws.
Each knob cover can be locked with the included keys to secure the feet to your roof.
Average Customer Rating: 4.3 out of 5 stars (4 Customer Reviews)
These feet let you mount 2 Inno square crossbars to your vehicle's rain gutters. Feet clamp onto rain gutters and tighten down with locking knobs built into the covers. Feet provide 9-7/8" of load bar clearance above your domed roof.Overall product is sufficient. Lock mechanism is a bit janky and is unlikely to prevent a person from unscrewing the knob (the mechanism provides a slight resistance but is easily overcome with a strong push). Worse, when used with the Inno crossbar on a 2021 Jeep Wrangler JL, the combination produces a very loud whistle that onsets at about 45mph. It isnt clear whether the noise is comming from the crossbars or the feet. I suspect it is the feet, based on the geometry of the sheet metal which presents an open cross section bounded by sharp edges, which is oriented perpendicular to the air stream which likely causes an aerodynamic resonance (much like a wind instrument or a whistle). Obnoxious enough to render it useless. Unfortunately, etrailer wont accept returns which have been used. That is a bit unfair, since many defects cannot be discovered until a product is actually used. Boooo.
Do you have a question about this Roof Rack?
Condition: Surface Scratches
Notes: Item has several scratches and scraped on the paint.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Katrina D.
7/8/2023
If you are having problems with wind noise, I would recommend using a fairing like part # INA261.