Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Throw this storage cover over your Class C motorhome to protect it while you're storing it for the season. The contoured cover conforms to the shape of your RV and secures with the integrated straps so it won't flap in the wind.
Features:
Specs:
Summer is over, and you're worried about your Class C motorhome getting dirty and damaged in storage during high winds, snow flurries, and spring thunderstorms. Whether you're storing your RV in the sunny south, rainy northwest, or snowy north, this heavy-duty cover is designed to protect your RV in any climate. When you keep your RV covered during the winter, you are less likely to need to wash and wax it at the start of the camping season. And if you want to trade your RV in for a newer model later down the road, this cover will help maintain that resale value.
The durable, high-density Olefin top panel won't crack or fade when exposed to harmful UV rays and won't let dirt and dust particles cake onto the surface of your RV. It also beads water when it rains to eliminate the black streaks and corrosion you tend to see on the sides and roof of your RV.
How to Measure Your Class C Motorhome
To determine if this cover will work for you, measure the overall length of your RV from the front bumper to the rear bumper, making sure you're accounting for any spare tire carriers and ladders on the back. Then measure the overall height from the bottom of the RV chassis to the top of the roof. Do not include any AC units, vents, or antennas in your height measurement, as the cover is already designed to accommodate them.
Securing the Cover onto Your RV
The included ladder cap and rain gutter covers help prevent the cover from splitting on those areas of the RV, so install those first. Then unroll the cover and carefully spread it evenly around your motorhome, making sure you don't pull too hard and tear the fabric. The cover is labeled with "front" and "rear" to help you position the cover correctly on your RV.
Once the cover is in place, pull on the cinch ropes on the front and the rear until the cover fits snugly around the contours of your rig. These ropes remove any excess slack in the material, especially if your RV is slightly shorter in length. Then toss the weighted straps underneath your RV to the other side and buckle them together. These straps keep the cover secure on your RV, preventing it from flapping in the wind and damaging the paint job.
And if you still need to winterize or access one of the cargo compartments, you can use the zippered panels on the passenger's side to easily access the interior of your RV without having to completely remove the cover.
Average Customer Rating: 4.5 out of 5 stars (504 Customer Reviews)
Throw this storage cover over your Class C motorhome to protect it while you're storing it for the season. The contoured cover conforms to the shape of your RV and secures with the integrated straps so it won't flap in the wind.I received this item yesterday and the install was a bit much for just one person. I was able to get it all installed and actually like the fit for my Thor Freedom Elite 22FE 2018 RV. The option to have access to the inside by a simple zipper and snap is a huge benefit long term.
Not sure of the cover will be putting it on in the fall will let you know then but from what I can see now it looks good
We purchased the rv cover referenced below.
Your company was great to deal with. The cover arrived in a prompt manner.
Heavy cover, so it should last. Looks to be high quality materials too. Have not put it on my 2016 Jayco Melbourne 24K yet, as am waiting to wash and wax it before putting the cover on.
Fit was perfect for a Winnebago Navion. We park under some trees that drop a lot of leaves, and if not removed, can stain the rigs finish. This cover has protected the rig and cut my cleanup time immensely. It’s also very easy to install, following the included instructions. I can put it on by myself.
We have been very happy with the service and updates given to us on the cover for our Winnebago View 24D. Our cover came damaged and it was replaced right away. The new one fits the RV great as you can see in the photos
The material seems strong but lightweight and I just put it on my camper by myself without any problems.
This cover works well to keep the motorhome covered, and dry. I was surprised that it worked so well.
Great RV cover for 24J Sprinter. Helps protect paint from the elements of CA sun & rain. Appears to be a higher quality then cheaper covers purchased in the past thru Camping catalogs... so hoping it will last longer. Comes with a 3 year warranty. Been happy with other purchase from etrailer, they stand behind their products and have very good customer service.
Fit well stayed on all winter storage
This cover exceeded our expectations. Thick material looks brand new going into its second year. Lots of straps so we could adjust it to hold against winter winds. Bonus: straps are covered on all four corners. Each corner, top and bottom, can be gathered for a custom fit. Spent time fitting it last year, this year just shook it out and slipped it on. Definitely worth every nickel we spent on it. Highly recommend.
Arrived on time and I unboxed looks good so far haven’t tried it on yet.
It is still in the package. When I actually unwrap it and use it I will rate it again. I fully expect it to be excellent!
Good fit on my 24 foot Class-C and install gets easier each time.
I have a 2022 leisure travel van unity and it fit perfectly and is well designed. I’m Very happy
It's gonna be hard to put up alone!
I have a 2018 Lance 1995. This is the right size cover for this trailer. This is a good universal type cover ,but it is not a custom fit. This cover looks like it will work fine, but since the trailer has a curved from section it does not fit as well in the front as it does in the back. I have had to use bungee cords to help take up the slack and make a area for water to drain off the roof. I had to decide to either cover the propane tanks or the read bumper. I chose the tanks. If you get the next size up there will be too much cover and you will have issues dealing with the extra material. This cover is just long enough to reach the bottom of the siding with no extra material. It was arrived quickly from E Trailer. I suggest watching the installation video. It was helpful.
2 people installed the cover today in a light wind. I am a mechanical designer. I am not receiving any compensation for this review. This is our first cover going on our first RV. We ordered/received the the 22' long cover for the trailer which measures ~22' bumper to hitch ball plus some for the spare tire on the bumper. I am happy with the fit though it looks like it would fit a trailer whose "box" is about 3' longer and still go over the tanks and spare tire. I thought the ordering instructions said to include the tanks in the front and the bumper/spare tire in the back when determining the length.
There were no instructions except to "dull" sharp corners. The little foam tubes went on the gutter ends and I used black tape around sharp points on the bottom.
The only bad thing about the cover are the buckles/buckles: they worked but 1) they are too light duty, too weak, and the sections too thin in my opinion and 2) the design stinks because I want to hold the female end right where you press to release the buckle which was annoying but I figured out how to do it and it was more awkward than it needed to be considering other similar buckle types.
I got on the roof to pull the cover over from the side (not the front or back) over the ac, tv antenna, bathroom vent, etc and that worked well. It was too hard to pull the cover over the first top corner with me on a ladder and wife on the ground. If I could not get on the roof, we both would need to be on ladders. Or tie a rope to the straps and try to pull it over the top. Maybe try to pull it over from the front.
The fit is very good: good width, more than enough length and good height. I am glad the height was no taller so as to keep it from wrapping around the bottom which is sharp and the trim ends are sharp. We connected the underneath straps first, then the front and back then cinched the top and bottom corners to pull the whole thing tight along the perimeter.
All of the buckles are the same so I was able to repurpose some straps to wrap around the spare tire and bumper and connect to some other buckles for a better tie down arrangement. I would have liked a strap in the front middle to tie down under the tanks.
Otherwise, there are just the right number of straps underneath. I don't think more would help and less would make me nervous.
There are 2 flaps zipped on one side for a door at the front and/or the rear. I unzipped the front flap, sloppily rolled it up and attached the 3 velcro straps that hold the roll up. I had to undo 1 bottom strap from the flap so I need to rereview this after we have a good wind/rain storm but I think it will be ok. See pics. The trailer is parked in between a tree, shrubs, the house and the neighbors house so it is somewhat protected from some wind. Someone else may need to add a tie along the side bottom to take the place of the rolled up flap. When the flap is down, zipped, it is velcro'd at the bottom to the cover.
The perimeter cinch straps have a sleeve layered on top of the sleeve the strap is in which is great for 2 reasons. 1) you can stick your finger in it to grab it to push the cover back and pull out the strap, then 2) you can regrab it while pulling the strap through the buckle and keep the stress off the strap. This will keep the strap from scrapping and wearing while pulling through the buckle. I took pics and a video of this. And 3), this is another sleeve you can run a line through if needed.
Overall, I am very happy with this cover! It is reasonably thick material, aerated and the holes are covered with a flap to keep rain out, has a lot of straps which are well attached to the cover. The installation went better than expected at ~ 45 minutes and next time I expect to do it in half the time. The door access is a great feature. The cover went over the spare tire and the dual 20 lb tanks plus batteries in the front. One of the pics has the trailer model so you can see for yourself how well this cover fits this trailer. I expect this cover to last until a sharp corner some place tears a hole or the sun finally gets to it. The cover comes with a bag but I have not used it yet. And found a piece of velcro but not sure what for.
PS: Finally looked at the storage bag and found the instructions, self adhesive material to fix holes and weights that can be attached to the straps to throw underneath the vehicle (not over b/c the weight could break a window or make a dent) in a side pocket.
The quality and fit are very nice. For reference, my Outdoor RV measured 20'10" and additional 16" for the spare tire for total 22'2" Plenty of room to install. The roof fabric was ample for the AC unit. Also noted the cover is full grey material and the white top is added over the grey to make the roof double thick which is a nice bonus. Please note that the manufacturer's paperwork says this cover is NOT water proof.
Do you have a question about this RV Cover?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Heidi
11/17/2022
Awesome and easy to put on the RV