Replacement Glass for K-Source Snap & Zap Custom Towing Mirror - Passenger Side

Video Transcript for Review of K Source - Custom Towing Mirrors - KS80911GRH

Today we're going to take a look at the Replacement Glass for K- Source Snap & Zap Custom Towing Mirror. This is going to be for the passenger side, and this is just going to be that direct replacement for the glass assembly on our towing mirror. It's just going to easily install. The way that you'll get this in there is you'll first want to remove the old broken glass from your towing mirror assembly. You'll want to tip that up in the housing so you can get access to the bolt to loosen that circular opening there. Once that's loosened up on your original glass, you'll pop that out, and then you'll take your new replacement glass and pop that back onto that ball joint on our original housing.You can see we have sort of a indention there in that circular plate so it's going to fit over that ball joint to allow us to adjust our mirror to where we need it to be.

Once you have this popped into place, you'll just tighten down that bolt again until it's tight enough to hold it snug, but we still have some adjustability in our mirror. One thing to keep in mind whenever you're popping this into place is that you probably want to have a towel or some type of fabric or something to be a little bit of a cushion in between your hand and the glass so you don't accidentally pop that glass and break your new replacement.Again, this is just going to be that direct replacement for your K-Source Snap & Zap Custom Towing Mirror. It's going to have the OE-grade flat glass with first-surface plating, and that's just going to reflect a clear image, but also a true representation of whatever's behind you, so it doesn't have a convex design to it, so you don't have to worry about it distorting the image in any way. It's just going to be a true representation of the object size.Again, this is going to be for the passenger side. This is also a fit for the KS80910 Towing Mirrors.

That comes as a kit, and so if you needed the glass for the driver's side or the left-hand side, it's going to be a very similar part number to this. Instead of KS80911GRH, the left-hand side is going to be KS80911GLH. LH for left hand, RH for right hand.Again, this is going to fit that KS80910 mirror. The fit for that is going to be the 2014 to 2018 GMC Sierra 1500, and also the Sierra 1500 Limited for 2019. It's also going to fit the 2015 to 2019 GMC Sierra 2500 and 3500, and for our Chevy side, it's going to fit the 2014 to 2018 Chevy Silverado 1500 and the 2015 to 2019 Chevrolet Silverado 2500 and the 3500.

Those are going to be the fits for our original mirror, so this is going to be that replacement glass for our mirror set.As far as the dimensions, of course it is going to be a direct fit from K-Source. It'll just replace that glass, but just so you can get an idea of how big this is going to be. The width is going to be pretty much the same going along this curve, and that's going to be about 3 1/2 inches from outside edge to outside edge. The overall height going from the widest point there is going to be about 5 1/8 inch. That's just sort of a rough measurement there.

It is going to again be a direct replacement for your K-Source Snap & Zap Custom Towing Mirror. And that's going to do it for our look at the Replacement Glass for our passenger side on our K-Source Snap & Zap Custom Towing Mirror.