Remote Inlet Air Filter Assembly for Bulldog Winch Air Tank - Metal - 3/8" NPT

Video Transcript for Review of Bulldog Winch Air Tank Parts - Metal Remote Inlet Air Filter - BDW42027

Today, we're going to be taking a quick look at the Remote Inlet Air Filter Assembly. This is to keep out any kind of water or dirt or debris from getting into the air inlet on your air tank for your onboard compressor. It's made of a sturdy metal construction. So it's going to last for a long time, has this little bracket coming off of it that gives you an attachment point to any existing factory holes on your vehicle, or it can also be an anchor point for a zip tie to go around it and hold it in place. Whenever you're mounting it, you do want to keep it in a dry area. So if you're mounting your compressor on the underside of your vehicle, usually you can mount this pretty high up in the wheel well or next to it.You just want to make sure that it's away from any kind of over spray from your tires and wheels so that it stays nice and dry.

Inside we'll find our actual filter. So you should be able to just thread this top portion off, it's a little hard to get a hand on it since, pretty much are grabbing that bracket. I'll see if I can show that to you guys.There we go. Turn that, and then there's our filter inside. So it does come with an air filter it's kind of in two pieces.

So it'll keep out any dirt or debris and any water from getting into your compressor and causing issues. You can always replace that and you can find replacement filters here at etrailer.com. Get this line back up. We'll have a couple little cutouts there, so just need to get that threaded back down. And then on the backside, we'll have our connection point and we'll have our two NTP fittings.

These are going to have a three-eighths inch NTP fitting on the end so we can thread our female and onto the filter and then the other one would go onto our compressor and in between you'd want to use your three eighth inch air tube. So we just pushed that barb fitting into the hose and you want to push it all the way down, so the edge of that hose is flush with the edge of the fitting. Now the air tube is sold separately. Again, can find this right here at etrailer.com.Let's talk about some measurements. Our filter is top portion is about two and three eighths inches wide.

We go to the little plastic bracket portion. It's a bit wider. It's about two and three quarter inches and then if we go to that end of the little attachment point, it's about three and three eighths, or excuse me, three and three quarters. Front and back, it's about one and one and five eighths inches thick. We go from the front here to the back of the threads, comes with a one-year limited warranty, and that's going to do it for our look at the Remote Inlet Air Filter Assembly for Bulldog Winch Air Tank..