Trailer Wiring Harness Installation - 2013 Toyota Sienna Video

The main difference between the Curt #C13264 and the etrailer #e98905 hitch receivers lies in the matte black powder coat finish of the etrailer hitch versus the traditional glossy finish of the Curt hitch. I recommend the #e98905 because the matte…

For your 2020 Toyota Sienna I highly recommend the etrailer.com Trailer Hitch #e98853 because of its hidden-crosstube design and unique matte black finish that matches the Sienna well and is less prone to scratches. This Class III hitch will line up…

You will need to start with a 4-way (if you do not have one) on your 2014 Toyota Sienna. For that you would want the #118498 which is a confirmed fit. From there you would need to convert the 4-way to a 7-way so that you can install the brake…

Based on my research it looks like the factory towing package for the 2018 Toyota Sienna consists of an engine oil cooler along with a heavy-duty radiator and fan. The factory towing package is standard for the XLE model like what you have. With the…

The T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector #118498 that you referenced comes with everything you'll need to install it. No additional items would need be needed to install. I attached an install video for this kit on a…

I took a look at all of the hitches that fit a 2013 Toyota Sienna, and the one that is going to give you the most ground clearance is the Draw-Tite Trailer Hitch Receiver #76112. As you can see in the linked video install, when we test fit this hitch…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

You can trim the appearance panel underneath your 2013 Toyota Sienna and reinstall it when using Draw-Tite trailer hitch #75237. If you choose not to you can just leave it off. I have linked the instructions that mention where to trim. You would not…

We have just what you're looking for. You'll want to start with the Tekonsha T-One #118498, which will put a 4 way connector on your 2013 Toyota Sienna. Once you've installed that harness you'll want to use the #ETBC7L which will…

It's not by much but it looks like the Draw Tite Hitch part #36513 tucks a little bit closer to the rear bumper than the Curt part #C12065. The difference is right around an inch. Another advantage the Draw Tite has is that it doesn't require…

We have installed some of our trailer hitches on 2013 Toyota Siennas, and we check the clearance measurements when we do installations so that customers can find a suitable hitch for their need. unfortunately, The height of the Sienna does have a…

At most, the 2011 Toyota Sienna can tow 3,500 pounds and to reach that it must have the V6 motor and the factory towing package. If it has the V6 but not the towing package it is limited to 1,500 pounds. And if it has the 4 cylinder motor it can tow…