Trailer Wiring Harness Installation - 2008 Honda Civic Video

Yes, the Curt hitch part #C11391 that you referenced does fit your 2014 Honda Civic SI Sedan. I attached a picture of this hitch and install video of it on a 2015 Honda Civic Sedan SI just like yours.

Exhaust melting cargo on a cargo carrier isn't a super common problem, but we are aware that it does happen on occasion. Especially if the cargo carrier is at the same height as the exhaust, relatively close to it, and/or the material in the…

The Tow Ready Vehicle To Vehicle Taillight Converter, #118158, you have referenced will not be needed since you will be staying with a 3-wire system (separate stop and tail lights)on both of your vehicles. The converter is only needed if you had a…

Typically, the tow dolly will have a set of lights on the fenders so you will not need to wire up your vehicle for this in addition to that. If your dolly system does not already have lights we offer magnetic towing lights #TL21RK or you could wire…

Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector Item #C56051 is compatible with LED trailer lights. I have included a link below to a video showing an example installation for you.

The Hopkins #48955 taillight diode kit can indeed be used to drive the running /brake lights on your Captiva like a three function lamp, without using the amber bulb for a turn signal. See the diagram I provided, and I'll also send you a copy as…

It might be possible to add trailer brakes to your tow dolly but due to the age of it I can't give you the exact parts you'd need. You'd have to take your wheels and hubs off to check out and measure the spindle to determine if it would…

If you have a 3,500 lb AL-KO axle and the brakes are indeed 10 inches, you can use Trailer Hub and Drum Assembly, #AKHD-545-35-K for a standard spindle and #AKHD-545-35-EZ-K for an E-Z lube spindle. For brakes you can use etrailer.com Trailer Brake…

The long and short of it is that you need to route wiring from the cold side of the stop light switch (only gets hot when brake pedal is pressed) on your dinghy up to the location that you are mounting the RoadMaster Replacement LED Display Monitor…

The axle-less trailer suspension system I recommend is the Timbren Axle-Less Trailer Suspension System w Electric Brake Hubs, part #A35RS545E. This system has a 3,500 lb weight capacity, has 5 on 4-1/2 bolt pattern on the electric brake hubs. This…

I went out to the warehouse and measured the Replacement Hub Assembly for Demco Kar Kaddy, Tow IT II, or Penske Tow Dolly #DM04369 from the gold piece rearward, and it measured 4-1/4" long.