Swagman Trailhead Hitch Bike Rack Review - 2007 Infiniti G35 Video

Yes, fascia trimming is required to install Draw-Tite trailer hitch #DT24950 on a 2016 Audi A4. The area that needs to be trimmed is up underneath the vehicle and not visible otherwise. I have included a diagram that shows the area that needs to be…

There are both Class I and Class III trailer hitches available that are confirmed to fit your 2010 Honda CR-V. The available Class I hitches, such as the Draw-Tite Sport Frame #24792, feature a square tube design, while the Class III hitches like the…

Exhaust components can be pretty stubborn, but you have done everything correct so far. Once you loosen the straps and remove the exhaust hangers the pipes should be able to pivot down. I'd try letting the WD40 sit for a while and try again.…

The Thule OutWay Platform-Style 2 Bike Carrier, item #TH65JV, is recommended for your vehicle by the manufacturer, but my contact there said that they were not able to test vehicles with the satellite radio antenna, that you mentioned, on the trunk…

I spoke with my contact at Draw-Tite and they said that the Draw-Tite Class I 1-1/4 Inch Hitch, part #24863, will fit a 2011 Ford Mustang convertible. This hitch has a gross towing weight capacity of 2,000 lbs. and a tongue weight capacity of 200…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…