Optronics Trailer Lights - Tail Lights - STL64RB Review Video

Thanks for the axle information, Mike! Here are the correct parts according to my contact at Curt: - Bearing #02475 and Race #02420 - Bearing #25580 and Race #25520 - Grease Seals #RG06-070

There are differences in them but we do have what you are looking for and they can in some situations be used together. The Replacement Trailer Hub Bearing you have part #02475 and Replacement Race for 02475 Bearing part #02420 are designed to work…

Hey Daniel, There is one plug-in trailer wire harness available for your 2013 Chevy Spark with the Hopkins #HM11141120. This will tee into your tail light wiring and have a wire to run up to the battery with an inline fuse to power the converter box.…

The wiring of the Thinline trailer light #STL64RB is a 16 gauge so sticking with that would be a good idea I'd say. We offer 16 gauge wire by the foot with part #16-1-1 as well.

If the trailer you are planning on towing has LED lights, the adapter you can use is part #C35FR. This adapter is needed because you have a bulb-out sensor on your Cayenne. When you use a trailer with LEDs, they draw so little power and cause the…

The TorkLift Custom Frame-Mounted Camper Tie-Downs #TL23RR are confirmed to fit your 2021 Ram 1500 Crew Cab with the 67" bed length as long as you do not have the Mopar rear-mounted kick out steps that are mounted under the bumper. If you also…

For your 2013 Chevy Spark we only have Class I hitches available like the Curt #C11334 since it's a lighter duty vehicle. Higher hitch Classes are only available on heavier duty vehicles like SUVs. But we do have a Class I compatible e-bike rack…

Going by the colors that you mentioned, it sounds like you have the typical set-up, green wire for right turn and brake, white wire for ground, yellow wire for left turn and brake, brown with green wire for right side running lights, and brown with…

Some 5-Pole flat connectors use a total of 6 wires. They operate as follows: Blue - trailer brakes Green - right hand brake and turn signals Yellow - left hand brake and turn signals Brown/Green - right hand running lights Brown/Yellow - left hand…

Did you have a 4-pin connector that had 5 wires or was it a 5-pin connector? There is a big difference since you normally see a 5-pin connector on a boat trailer with the 5th pin used for an electric reverse lockout solenoid on a brake actuating…

The Lippert 2420801 hub is an 8k hub with an 8 lug bolt pattern so for a replacement you'd just need the part #8-285-10UC3-A.

EZ Lube Dust Caps, like #DC200L-DCRP, have a rubber plug that can be removed to access the zerk fitting. The rubber plug can be removed by gently prying it up with a flathead screwdriver. If your dust cap is in good condition and you want to avoid…