Customers compare AM3H480 to these similar products
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
The Loadstar trailer tires are made in both China and Taiwan. You will want to check the inside of the tire and if there is wear also on the inside it will be from low tire pressure. Always make sure to inflate trailer tires to the maximum psi…
view full answer...Yes, the Kenda 205/65-10 Bias Trailer Tire with 10" White Wheel #AM3H480 is typically used for 3,500 lb axles/hubs which you can see based off of the 1,650 lbs at 90 psi weight rating. Just make sure that your hubs use the 5 on…
view full answer...For your Blizzard 10T Snowmobile trailer, the 2,200 lb GVWR with the Dexter torsion axle means we do not have a direct replacement. We do however have a better option that will work for you whether you have 78 or 79 inch hub face to hub face…
view full answer...The 4 mounting bolts on the Dexter Hydraulic Trailer Brake Kit - Uni-Servo - 7" - Left and Right Hand Assemblies - 2.5K #23-398-399 you were looking at are 2-3/4" apart on center or 4" apart when measured diagonally and will fit your…
view full answer...Yes, trailer tires are rated by tire. So for example, the Kenda 4.80/4.00-8 Load Range C Tire, part #AM10004, is rated up to 745 pounds at 90 psi. Two tires on one axle are rated up to 1,490 pounds. You still need to verify the weight capacity of the…
view full answer...Yes, Dutton-Lainson Heavy Duty Brake Winch, TUFFPLATE Finish, Self-Locking, 3-1/8" Drum - 3,500 lbs. Item #DL24844 can be used for boat lift applications and will accept the big wheel that replaces the handle.
view full answer...The 205/65-10 and the 20.5 x 8-10 would be very close in size. Assuming that 20.5 is the diameter of the tire and 8 is the width. The Kenda 205/65-10 Bias Trailer Tire with 10 inch White Wheel, #AM3H390, for example, is 8.3 inches wide with a…
view full answer...It could be a tow package fuse on the vehicle. Use the owners manual to find the locations of fuses/relays related to the tow package wiring to check them and replace as needed. If the issue is not a fuse or relay then you can test the vehicle side…
view full answer...The 4-way on your trailer is what's known as a wishbone connector like part #A35W42B. Two of the wires are the running light circuit which is a little easier to install since you can run one down each side of the trailer. This way you don't…
view full answer...I pulled a sample of the Dutton-Lainson Hand Winch #DL15002 from our stock and took measurements of the mounting surface. The overall dimensions and mounting hole spacing are shown on the attached photo. The overall size of the plate is 3-1/2-inches…
view full answer...Typically the axle diameter is a good way to determine capacity but with the capacities being as close as your they could be the same diameter. A 3,500 lb axle should be 2-3/8 inches in diameter. You can also check the plate up near the coupler of…
view full answer...When measuring an axle to determine the weight capacity you'll want to measure along the actual axle tube. Anywhere between the spring seats will work fine. I also recommend measuring with a digital caliper like #PTW80157 to get an accurate…
view full answer...