Customers compare AM3H325 to these similar products
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
The 1-7/8 inch width is what is rounded up to 2 inches which is a standard width for winch straps. The 14 foot length is not something we carry. I recommend the Hand Winch Strap with Safety Hook, 2" Wide x 15' Long - 4,000 lbs…
view full answer...Replacement arms are available for the Roadmaster EZ5 Base Plate Kit #RM-521569-5 for your 2015 Honda Fit with the part #RM-ARMS. When the original base plate brackets and arms were manufactured, they were made as one part. To be sure that the new…
view full answer...The Replacement Mounting Hardware part #LC701665 comes with the Extension Rods, Extension Rod Bracket, Torsion Arm Caps, and various hardware. I am not sure what all you have now but it sounds like you might also need the torsion heads, part…
view full answer...The #37213635 JR Products Replacement Landing Gear Switch you'd mentioned would be a proper replacement for your existing Atwood 70254 landing gear switch. If you wanted the switch, wiring harness and the bezel for the switch, use the…
view full answer...The proper replacement inner assembly member for your UFP 34043 would be indeed be the the Dexter #DX99FR which is compatible with disc brakes. The replacement has an electric lock out and has a 7500K capacity and is intended to work with a 2 inch…
view full answer...While we have the measurements of the exact ground clearance height for our hitches we carry for a 2022 Toyota Sienna, we do have available measurements for a 2021 model. While these are not exact, the measurements will not deviate much from the…
view full answer...The portion you need to measure is not the cap, but the the hub bore. Remove the grease caps and measure the diameter of the opening the caps occupy. This is the hub bore. You will need an accurate measuring devices like a set of dial calipers that…
view full answer...In order to find the correct replacement bearings and bearing buddies for your ShoreLand'r Profile 2000, we will need to know the current bearing part numbers. If you cannot find the part numbers, we will need to take some measurements.…
view full answer...The great thing about Bearing Buddy like part #BB1781 is that when you add grease to your system with the included fitting, it will move the spring-loaded piston outward and allow grease to seep around the edges to keep from damaging the seal. You…
view full answer...For the 1/2 inch lugs with your 8 inch wheels, you will want to use a torque range of 75 to 85 ft-lbs. I have also attached a helpful image that breaks down the different torque specifications depending on the wheel size/type and stud size that you…
view full answer...I'll start out by saying that you shouldn't need to replace your wheels if you switch from bias to radial tires, or vice versa; so that shouldn't dictate what you need to do. With that said, I may have a solution for you but we do not…
view full answer...The best way to select a new hub is to match it based on the bearing set used in the original part. New hubs must use the same bearings as your old ones in order for them to fit on your spindles, so if you can find the part numbers from your inner…
view full answer...