Customers compare CE32005G to these similar products
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
The CE Smith Multi Sport Plus Boat and Kayak Trailer w/ Bunks #CE48870 that you referenced was designed to be used with boats that are up to 14 feet in length like what you have now. I attached a picture that shows the range of where the winch…
view full answer...I can help you add reverse lights to your trailer. Yes, It is important to pay attention to DOT compliance when adding lights on your boat trailer. Compliance will be met if you use the Optronics #BUL10CB light as your backup light. The #BUL72CB is…
view full answer...I went out in the warehouse and pulled the Redline Grease Seal, part #13194. It does have the markings on the inside of the seal that say TCM 13194 TM Taiwan and the number 11. It also has the spring around the inside lip. This seal will work for…
view full answer...You will first want to check the fuses on your tow vehicle. Some vehicles could have fuses for operating the turn signals and brake lights of a towing package. You will want to check if they are installed and working properly. The next thing is to…
view full answer...The best way to choose the correct replacement leaf spring for a trailer is to measure the existing spring. If this cannot be done however then you can get a good idea of what the spring length will be based on the hanger spacing but this is not as…
view full answer...The bolt hole spacing for the CE Smith Front/Rear Hanger Bracket for Double-Eye Springs #CE14026G is 4-3/8" x 1-5/8". I've attached a dimensional photo for you to check out as well as a review video to reference.
view full answer...That's not a number we are familiar with. What's the inner diameter of the bearing? If it's 1 inch most likely you have a L44643 and the 6 just happens to look like a 5.
view full answer...The only hanger kits we have that are bolt on are the #CE14035G40 and #CE14026G. Your typical double-eye leaf spring is going to be 1-3/4" wide so neither of these would work. This means the only option would be weld-on hangers. For replacement…
view full answer...I contacted our representative at Redline and he informed me that the Single-Axle Trailer Hanger Kit for Double-Eye Springs - 3-1/4 Front, 1-1/2 Rear, part #APS4, must be welded to the trailer frame. He informed me that there should be a hole to make…
view full answer...The shackle straps need to be placed on the outside of the rear leaf spring hangers which you can see in the attached photo. Furthermore, the distance between the two mounting plates (inside to inside) on your leaf spring hangers should be…
view full answer...On a single axle trailer, the shackle straps must be to the rear of the axle, attaching the leaf spring to the spring hanger. This allows the axle to deflect upwards and to the rear if you hit a bump. If the shackle was at the front, the axle…
view full answer...For a single axle trailer, you want the shackle strap to be able to move so that you have the spring deflection needed for your suspension. Angled like the photo or even almost vertical is fine you just don't want the shackle strap to bind and…
view full answer...