B and W Ball Mounts - Fixed Ball Mount - BWBMHD30014 Review Video

I spoke with my contact at Demco and they offer three different sizes for the replacement wheel straps for their Kar Kaddy. For standard you would want the #DM03528, for small #DM03528-81 and for large #DM03528-93. It sounds like you are looking…

Demco doesn't have a big list out there of what tires work with the 3-Point Standard Wheel Tie-Down Strap #DM03528 (because that would be huge) but they do have a calculator that can be used to determine what size you need for your tire size.…

You can have a 2-5/16 inch hitch ball on either a 1 inch or 1-1/4 inch shank. The nut on a hitch ball with a 1-1/4 inch shank takes a wrench with a 1-7/8 inch socket. A hitch ball with a 1 inch shank will take a wrench with a 1-1/2 inch socket. You…

The wiring for the Furrion Vision S Wireless RV Backup Camera System w/ Night Vision #FOS05TASF can simply be spliced into the running light wiring. You can remove strip back the casing and twist the bare wires of the #FOS05TASF and the running…

Demco doesn't sell the Acetyl copolymer lining used in their #DM8669113 brake actuator as a separate item. I spoke with my Demco representative who said that the lining wouldn't have any influence on a swaying #DM9713045 Kar Kaddy SS car…

Basically, one friction-style sway control can be used for trailers with up to 6,000-lb GTW. If your trailer's GTW is between 6,000 lbs and 10,000 lbs, you will need two sway-control units, one on each side of the trailer. You will also want to…

For your short tongue on your new trailer, I recommend the Curt Short-Arm Weight Distribution systems with sway Control. This will give you the friction sway bar that will help control sway, but will need to be disconnected prior to backing up.…

Curt recommends the use of 250 ft/lbs of torque when tightening the nuts of their hitch balls with a 1 inch diameter shank like the part #C40034 that you referenced. The general rule is for a 3/4" shank tighten to 150 ft/lbs For a 1" shank…

In the traditional way of measuring rise/drop the BulletProof 2-Ball Mount part #HD206 can do a drop of up to 7-1/4 inches. This would be measured from the top of the hitch opening/ball mount shank down to the base of where the hitch ball sits on the…

Yes, you can use the Reese Friction Sway control part #83660 without a weight distribution system. You would just need to use the tab part #RP26003 on the ball mount as well.

It is perfectly safe to use a reducer sleeve like the Curt #C45405 to fit an accessory with a 2" shank into your 2-1/2" trailer hitch receiver. We do have options for you to use a ball mount with a 2-1/2" shank for when you want to tow…

Yes the attachement ball on the trailer of kits like the Curt Friction Sway Control for Weight Distribution Systems part #17200 can be added on by welding them. This is a very passive system and moving it out 3/8" from the actual frame will have…