Can DeeZee Trailer Tongue Toolbox part # DZ91717P Mount Flush to Front Trailer Wall
Question:
Can the back of the box be mounted flush against trailer and still allow the lid to open up to a full upright position? no space between box and trailer
asked by: Holly
Expert Reply:
The hinge of the DeeZee Specialty Series Trailer Tongue Toolbox part # DZ91717P is located on the back edge of the toolbox so you would not be able to mount this box flush to the front of your trailer.
You will need to mount the box a few inches in front of the front wall of your trailer. Your best bet would be to set the box on the trailer frame and then open the lid and see how much clearance you would need and then mount the box where needed.
I attached an install video for this product for you to check out as well.
Product Page this Question was Asked From
DeeZee Specialty Series Trailer Tongue Tool Box - A-Frame - Plastic - 6 Cu Ft - Black
- Trailer Tool Box
- A-Frame Trailer Tool Box
- 18 Inch Tall
- Plastic
- Medium Capacity
- 19-1/2 Inch Wide
- 36 Inch Long
- Black
- DeeZee
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Search Results: tongue box
- Video: DeeZee A-Frame Trailer Tongue Toolbox Installation
- Shop: Curt MV Weight Distribution System - Round Bar - 8,000 lbs GTW, 800 lbs TW
- Shop: DeeZee Specialty Series Trailer Tongue Tool Box - A-Frame - Aluminum - 7.24 Cu Ft - Silver
- Shop: Ark Drop Down Corner RV Stabilizer Jacks - 24" Long Corner Steadies - Silver - Qty 2
- Search Results: weight distribution hitch
- Article: Cargo Tie-Down Methods
- Video: etrailer E-Track Straps with Ratchets Review
- Video: etrailer Horizontal E-Track Installation - Enclosed Trailer
- Video: Review of Reese Weight Distribution Hitch - WD With Sway Control - RE94FR
- Video: Stallion Camper Jack - Stabilizer Jack - 288-01892-2 Review
- Video: DeeZee Trailer Toolbox - A-Frame Trailer Toolbox - DZ91717P Review
- Video: Review of etrailer E Track - E-Track Rails 4 Pack - e62VR
- Q&A: Can 2 of the DeeZee Tool Box # DZ91717P Install on Front of V-Nose Trailer
- Q&A: Can etrailer Horizontal E-Tracks e42VR Be Installed By An Amateur?
- Q&A: Can etrailer E-Track System Install on Aluminum Trailer Floor
- Q&A: What Does DeeZee Specialty Series Trailer Tongue Tool Box # DZ91717P Weigh
- Q&A: Does Trailer Frame have to be 36 Inches Wide to Install DeeZee Trailer Tongue Toolbox DZ91717P
- Q&A: A-Frame Trailer Mounted Toolbox with Lid that Opens a Full 90 Degrees
- Q&A: Can ETrack Be Installed on Enclosed Cargo Trailer with Honeycomb-Type Wall Panels
- Shop: Stallion Stabilizer Jacks - 7" Drop Leg Travel - 22-1/4" - Qty 2
- Shop: Reese Pro Round Bar Weight Distribution w Sway Control - Round Bar - 8,000 lbs GTW, 800 lbs TW
- Shop: DeeZee Specialty Series Trailer Tongue Tool Box - A-Frame - Plastic - 6 Cu Ft - Black
- Shop: Reese Dual Cam II Weight Distribution System w/ Sway Control - No Shank - 8K GTW, 800 TW
- Search Results: trailer tongue box
- Shop: Trailer Hitch
- Search Results: 44649
- Article: Trailer Wiring Diagrams
- Shop: Trailer Wiring
- Search Results: 68149