Landing Gear Recommendation for a 2002 Carriage Cameo Fifth Wheel Model F34CK3

Question

Question:

I need to replace my landing gear. But the space between the brackets is 15 inches instead of 17.5. Do you have any that will work on this camper?

asked by: Dean G

0

Expert Reply:

It looks like you will need to have your current brackets removed and have new ones welded on since none of the landing gear sets we offer are designed for brackets that are 15 inches apart. Any qualified welder could do this for you and would not be a big deal.

The Bulldog Tandem Landing Gear Set # BD500162 would be an excellent choice for your 2002 Carriage Cameo Fifth Wheel.

expert reply by: Jameson C

0

Answer 1

I have a few different options for you depending on the route you would like to take. However, regardless of which route you pursue you will need to take some measurements of your outer jack tube length and weld stop spacing. If you are handy and…

view full answer...

Answer 2

It sounds like the landing gear on your Fuzion Toy Hauler may have been overextended, which likely caused damage to the internal gears and screw. This "flopping" that you mentioned is essentially the unit trying to extend but since…

view full answer...

Answer 3

The standard replacement for the 5500-rpm landing gear motor 125340 that is used on Stromberg Carlson #LG-1 and #LG-2 landing gear is our part #LG-142178.

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

We do carry the 33" Ark Stabilizer Jack that you are looking for with part #ARK77FR. I was able to track down a few drawings that you should find helpful. These are for the 30" #ARK94FR and the 24" #ARK34FR Stabilizer jacks. I'm…

view full answer...

Answer 6

I contacted the manufacturer about the lengths for these stabilizer jacks and have included the information they were able to provide me. The Ark Drop Down Corner RV Stabilizer Jacks #ARK34FR are 422 mm (16.6") collapsed and 600mm (23.6")…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Landing Gear Recommendation for a 2002 Carriage Cameo Fifth Wheel Model F34CK3

Product Page this Question was Asked From

Continue Researching