Recommended Rear Camper Tie-Downs For A 2012 Ram 3500 With TorkLift SuperHitch Original # TLD1102

Question

Question:

I just installed the TDL 1102 Super hitch on my 2012 Ram 3500 HD. I had to remove the rear frame mount camper tie down. What is the correct P/N for the rear camper tie down to use with the factory hitch and and super combination for my truck.

asked by: James H

0

Expert Reply:

Hey James,

The correct rear camper tie-downs to go along with your new TorkLift SuperHitch Original Trailer Hitch Receiver # TLD1102 are going to be part # TLR3505. These will mount directly to the hitch at the end of the crosstube.

expert reply by: Kevin C

0

Answer 1

The TorkLift SpringLoad XL Turnbuckles #TLS9050A are not vehicle specific parts but they need to be used with the correct tie downs for your 2009 Dodge Ram Pickup that are vehicle specific. Those are the TorkLift Custom Frame-Mounted Camper Tie-Downs…

view full answer...

Answer 2

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 3

I checked with Curt and they do show the Curt Trailer Hitch Receiver part #C13233 as a fit for a 2022 Volvo XC90 All Models which includes the Recharge.

view full answer...

Answer 4

We have a really great kit that comes with everything you'd need to convert your 2021 Vanleigh Pinecrest 335RLP from tandem 6k drum brakes to electric over hydraulic disc brakes with the HydraStar Disc Brake Kit w/ Actuator for Triple Axle…

view full answer...

Answer 5

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 6

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 7

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 8

Hey James, The correct rear camper tie-downs to go along with your new TorkLift SuperHitch Original Trailer Hitch Receiver #TLD1102 are going to be part #TLR3505. These will mount directly to the hitch at the end of the crosstube.

view full answer...

Answer 9

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 10

Hello Bill. 5th wheel hitch technology has come a long way in the last several years. If you are using an old hitch, it is definitely not uncommon to have issues like this. Most older hitches, and even some new lower-end hitches will chuck quite a…

view full answer...

Answer 11

We definitely have some trailer jacks you can use as a replacement for your Dutton-Lainson but it doesn't look like anything we have will work as a direct replacement. If you'd like to stick with the Dutton-Lainson brand then I recommend…

view full answer...

Answer 12

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the breakaway…

view full answer...

Recommended Rear Camper Tie-Downs For A 2012 Ram 3500 With TorkLift SuperHitch Original # TLD1102

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching