Can Swagman E-Spec Bike Rack be Used with 48.8 inch Wheelbase E-Bike

Question

Question:

I am considering the Swagman espec bike rack. I have 2 ebikes with a wheelbase of 48.8 inches. The Swagman says max wheelbase of 48 inches. It looks like on the slide their is enough room to accommodate the extra 8 inches, but I would like your opinion

asked by: Andy

0

Expert Reply:

Hey Andy, the Swagman E-Spec part # S94FR would be able to accommodate a bike wheelbase that is 48.8 inches so it would work for you.

expert reply by: Jameson C

0

Andrew

2/28/2024

Thank you Jameson. Much appreciated!

Reply

Andy

2/22/2024

Thank you

Reply

Answer 1

For carrying heavier bikes with fenders like the e-bike and beach cruiser you mentioned the Swagman E-Spec part #S94FR would be your best option as it has the weight capacity needed, uses frame clamps that allow fit with fendered bikes, and also is…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 5

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

view full answer...

Answer 6

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 7

Hey Andy, the Swagman E-Spec part #S94FR would be able to accommodate a bike wheelbase that is 48.8 inches so it would work for you.

view full answer...

Answer 8

While we may have an option for you, we do not have the exact specs on your Allis grease seal part number 5013 29772. However, with the 1.6" ID and 2.5" OD measurements you provides, that is very close to our #58846. This particular grease…

view full answer...

Answer 9

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 10

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 11

The AL-KO trailer hub part number 8700 that you have is a 3,500 lb trailer hub/drum with a 5 on 4-1/2 inch bolt pattern. Based on that the #AKHD-545-35-EZ-K is the correct fit and would work great.

view full answer...

Answer 12

The squeaking noise on your trailer is probably coming from the joints in the suspension creating metal to metal friction. So, unless your original Equa-Flex Cusioned Equalizers are damaged or corroded, what will make the biggest difference is to…

view full answer...

Can Swagman E-Spec Bike Rack be Used with 48.8 inch Wheelbase E-Bike

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching