How to Determine Which SnapPads are Needed for a 2023 Keystone Cougar

Question

Question:

I was trying to figure out which snap pad I need for a 2023 keystone cougar 22mls. I see there are different sizes. Can you help?

asked by: Bryan J

0

Expert Reply:

All you're going to need to do is take note of the shape, the amount of jacks you have and measure the size of your jack feet.

For instance, if you had 4 6" square feet then you could use the SnapPad XTRA Square 6 Jack Pads for Lippert Leveling Systems w/ 6" Square Jack Feet # SN99FR you were looking at.

expert reply by: Bryce D

0

Answer 1

Yes, the SnapPad XTRA Jack Pads for Lippert Leveling Systems, #SN99FR do not require a tremendous amount of force to be seated. You will be okay. Happy Camping!

view full answer...

Answer 2

I checked with the manufacturer, SnapPad, and verified the XTRA pads you asked about do fit 5-3/4" jack feet; so you can use the following: - SnapPad XTRA Jack Pads for Lippert Leveling Systems w/ 6" Square Jack Feet #SN99FR The SnapPad…

view full answer...

Answer 3

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 4

Hey Joe, yes the Lippert stabilizer jack part #LC298707 does fit your Grand Design Transcend 245RL but it is sold individually so if you wanted a set for the front and the rear you would need to order a quantity of two.

view full answer...

Answer 5

I went out to our warehouse and test fit some SnapPads on the feet of the Lippert High-Speed Power Stabilizer Jack #LC298707 and found that the 6" square SnapPads were a fit. If your 2022 Forest River Vibe travel trailer only has one #LC298707…

view full answer...

Answer 6

Kenny, those bolts for the B&W Companion 5th Wheel Trailer Hitch #BWRVK3500-5W should be torqued to 40 ft. lbs. Also, the pivot arms would need to be torqued to 80 ft. lbs, the draw down bolt should be tighten to 60 ft.lbs and the arms should be…

view full answer...

Answer 7

All you're going to need to do is take note of the shape, the amount of jacks you have and measure the size of your jack feet. For instance, if you had 4 6" square feet then you could use the SnapPad XTRA Square 6 Jack Pads for Lippert…

view full answer...

Answer 8

Hey Brad, thanks a bunch for going ahead and getting all those measurements in advance. Based on the measurements you've given, the TorkLift GlowStep Revolution Uprising Steps w/ Booster Step #TL52SR will work perfect for your coach. These steps…

view full answer...