How Does the LED Light Kit for Post-Style Boat Guide-Ons Wire Up on a Boat Trailer

Question

Question:

How do you wire this unit into your trailer for each side. Does the unit have a ground wire?

asked by: Paul

1

Helpful Expert Reply:

The LED Light Kit for Post-Style Boat Guide-Ons, # CE27656A, will wire into the running light circuit of your boat trailer for power. They do have ground wires and will need to be grounded to a clean, corrosion free bare metal surface. Or if possible you can attach the grounds to the main trailer connector ground which is likely not going to be submerged on a boat trailer.

expert reply by: Michael H

1

Answer 1

The LED lights on the CE Smith Post-Style Guide-Ons #CE27760 do not have separate wiring for only the red portion of the LED Cap Light #CE27656A. They are normally used to act as running lights to make maneuvering the trailer easier in low light…

view full answer...

Answer 2

You would need to measure the inside diameter of the hub opening to determine which cap size is needed. You would want to choose a cap whose outside diameter matches the inside diameter of the hub. Some of the most common sizes are 1.980 inch, 1.986…

view full answer...

Answer 3

The CE Smith Post-Style Guide-Ons for Boat Trailers - 60" Long - I-Beam Clamps - White - Qty 2 #CE27648 are indeed an outer diameter of 2-3/8 inches. The LED Light Kit for Post-Style Boat Guide-Ons #CE27656A are often paired with this kit.

view full answer...

Answer 4

Most of the winches in the 2,500 lb. category are going to use the same type of handle. There are always exceptions but most use a common size. For your situation I recommend the 9-1/2" Long Winch Offset Replacement Handle by Dutton-Lainson part…

view full answer...

Answer 5

Since trailer leaf springs tend to stretch over time the key to picking out the correct replacement is to go with one slightly shorter than what your current one measures. So a 26 inch long spring would most likely be what you need. For a 2,000 lb…

view full answer...

Answer 6

The psi should be listed on the sidewall of the tire. It is recommended that tires always be inflated to the max psi. The max psi of the tire will depend on the tire's load range, not the weight of the trailer. For instance, we carry 5.30-12…

view full answer...

Answer 7

I spoke with CE Smith and they told me that the distance between the two smaller holes is 2". Attached is a diagram of this measurement for your reference.

view full answer...

Answer 8

Usually ladder racks use the inside edge of the top of the bed site to attach to the vehicle, but luckily there are exceptions to that. The Thule TracRac SR is typically compatible with tonneau covers that mount to the inside edges of the truck bed.…

view full answer...

Answer 9

The option we have for an LED light kit for post-style guide-ons for a boat trailer the LED Light Kit for Post-Style Boat Guide-Ons #CE27656A. These will fit on 2-3/8" outer diameter post-style PVC boat guides, but there isn't a way to wire…

view full answer...

Answer 10

The LED lights are sealed so they are not replaceable on the LED Light Kit for Post-Style Boat Guide-Ons #CE27656A. That said, LEDs are made to last for years or over a decade depending on your usage. And for a boat trailer that is only going to see…

view full answer...

How Does the LED Light Kit for Post-Style Boat Guide-Ons Wire Up on a Boat Trailer

Product Page this Question was Asked From

Continue Researching