What is the Mounting Hole Distance on the CE Smith Mounting Bracket?

Question

Question:

For this product, what is the distance between the holes for the trailer lights?

asked by: Gary J

0

Expert Reply:

I spoke with CE Smith and they told me that the distance between the two smaller holes is 2".

Attached is a diagram of this measurement for your reference.

expert reply by: Bryce D

0

Mounting Bracket Measurements
(click to enlarge)

Answer 1

Technically you could install LED tail light #STL78RB wherever you wanted. I haven't seen stop, tail, and turn lights on guide posts but I'm sure it can be done. If you just want lights on the guide posts to make them easier to see then there…

view full answer...

Answer 2

The most common cause for a trailer brake controller to display the 'no trailer connected' error message is a damaged or corroded connector on the trailer. Corrosion can occur inside a connector too so you'll want to re-inspect both the…

view full answer...

Answer 3

The issue you are having still sounds like there might be a weak or bad ground on the new LED lights. The mix between them and the incandescent assemblies at the rear of the trailer should not be causing this problem so it has to be something…

view full answer...

Answer 4

Your old trailer lights like #MCL67AB are grounded to the trailer via their mounting hardware. Since your new lamps use 2 wires, you'll connect the red wire to the trailer running lamp circuit and install a ring terminal on the end of the black…

view full answer...

Answer 5

If you wish to attach all of your lights to one dedicated ground wire that will work fine for you. Please be aware that modifying the mount in any manner will void the warranty for the light. The #MCL67AB light is designed to be grounded through the…

view full answer...

Answer 6

When a single function light only has 1 wire, like the Thinline LED Trailer Clearance or Side Marker Light #MCL67AB, it means that it grounds through the mounting hardware. If the mounting location doesn't have a clean, bare-metal surface then…

view full answer...

Answer 7

We had a customer who was able to replace his Dexter 8-155 hubs with the #8-201-5UC3-EZ that you referenced so they should work well for you. You can verify that this hub will work for you by pulling your current hub and making sure they have inner…

view full answer...

Answer 8

The LED lights on the CE Smith Post-Style Guide-Ons #CE27760 do not have separate wiring for only the red portion of the LED Cap Light #CE27656A. They are normally used to act as running lights to make maneuvering the trailer easier in low light…

view full answer...

What is the Mounting Hole Distance on the CE Smith Mounting Bracket?

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching