Customers compare CE27626 to these similar products
Products Featured in this Video
Today on our trailer, we're going to be taking a look at the CE Smith Post Style Guide Ons for Boat Trailers 40" Tall in Black, part #CE27626. This is going to look like once it's installed. You can see it's a nice large piece of PVC pipe. It's going to go around some 16 gauge galvanized steel that will prevent rusting. It's going to clamp onto your trailer with a no drill design. That will extend… see more >
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
The best way to determine the height needed is to measure from the top of your trailer frame to the top of the sides of your boat. If the 40" Tall Guide-Ons #CE27626 sit right at or slightly above the sides of your boat then the shorter…
view full answer...The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this…
view full answer...The brackets and U-Bolts that come with the CE Smith Post-Style Guide-Ons #CE27626 will fit 3" wide frames up to 4-1/4" tall. If you need longer U-Bolts then those are available as part #CE11416 which allow you to fit 3"…
view full answer...You are correct about the measurement. The CE Smith Post-Style Guide-Ons for Boat Trailers #CE27626 are measured from the bottom where it is galvanized to the top of the cap on the PVC pipes. This measurement is the overall height which is…
view full answer...The best guide-ons for a boat trailer are the post-style because they offer you the easiest way to guide your boat on the trailer, and the best of those is the 60 inch tall CE Smith Post-Style Guide-Ons with LED Lights for Boat Trailers #CE27760.…
view full answer...We have the CE Smith Post-Style Guide-Ons for Boat Trailers #CE27637 that extends out 19 inches. I attached a review video for this kit for you to check out as well.
view full answer...Most trailer wiring that runs to incandescent trailer lights is 16 gauge which would be a little less than what we would like, However for LED lighting 16 or 18 gauge is fine. To make your project easier I would use the Optronics #A35W42B wiring…
view full answer...I can help you find the correct parts for your EZ Loader trailer. Based on the photos you submitted, the #AL91RB will fit your style connector on your trailer. The amber light is #AL82AB, and the grommet you will need is #A91BOB. All these items…
view full answer...The psi should be listed on the sidewall of the tire. It is recommended that tires always be inflated to the max psi. The max psi of the tire will depend on the tire's load range, not the weight of the trailer. For instance, we carry 5.30-12…
view full answer...The short leg of the CE Smith #CE27648 Post-Style Guide-Ons measures 21-1/2 inches from the end of the leg to the inside edge of the upright and 23 inches to the outside of the upright. I've shown these dimensions in the provided photo. CE Smith…
view full answer...Sounds like you have a boat trailer that you tow your Triton 21RX with that has surge brakes that are locking up in reverse. This is a fairly common scenario that has an easy fix. With surge brakes, you have a brake actuator applying the needed…
view full answer...Yes, the CE Smith Bunk-Style Guide-Ons for Boat Trailers - 60" Long - 1 Pair #CE27600 can work on the inside of a pontoon boat. Based on the photo you may prefer the CE Smith 90-Degree Bunk Board Guide-On Kit #CE27600K90 which will includes…
view full answer...