Will Curt Trailer Hitch # C11497 Fit 2006 Subaru Impreza STi?

Question

Question:

Hello, I would like to know why this specifically says excluding the STI. I am looking for a receiver hitch for my 2006 STi. Thanks.

asked by: Geneviève

1

Helpful Expert Reply:

I do not know why it says that, as it shouldn't. Per my contact at Curt the Curt Trailer hitch # C11497 you were looking at fits all models of the 2006 Subaru Impreza so it will fit your STi model just fine.

expert reply by: Samuel C

1

Answer 1

The trailer hitch manufacturers do not test fit any vehicles with aftermarket products installed. They will only recommend a fitment on a 2007 Subaru Impreza WRX STI that has a factory exhaust. The Curt Class I 1-1/4 Inch Hitch, part #C11497, will…

view full answer...

Answer 2

You will need to trim the rear bumper fascia as needed to provide clearance for driver side mounting plate (approximately a 1/2 inch x 1/2 inch area). Other than that there are no other permanent modifications that need to be made to install this…

view full answer...

Answer 3

Per the instructions for the Curt Hitch, part #C11497, which is a Class l hitch, the tow hooks (referred to as tie-down brackets) are removed and are not reinstalled on your 2007 Subaru Impreza WRX. The hitch has a 2,000 lb towing weight capacity,…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

A TCM double-lip grease seal number 127194 has an inner diameter of 1.274-inches and an outer diameter of 1.983-inches according to my research. The available grease seal nearest to those dimensions that we offer is part #RG06-010, which is a…

view full answer...

Answer 8

The part you referenced 127194TB is a double-lip seal with an inner diameter of 1.274-inches and an outer diameter of 1.983-inches. The available seal nearest to those dimensions that we offer is part #RG06-010, which is a double-lip seal sold as a…

view full answer...

Answer 9

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

view full answer...

Answer 10

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 11

We do carry electric brake assemblies as well as hub/drum assemblies. To determine the correct fit, you will need to measure the spindles of your axles. I've attached a photo to assist with the measurement locations, and recommend using a digital…

view full answer...

Answer 12

In regards to the Correct Track Trailer Alignment and Lift Kit part #RR23QX, the kit provides a lift by essentially extending the hangers. This normally requires cutting off the old hangers and welding on new, taller ones but with this kit you…

view full answer...