Which Lug Nuts To Use On A 10K Dexter Axle  

A 16 inch tire will not fit on a 16.5 inch wheel. You would either need to get new 16 inch wheels with the proper bolt pattern to match what the hubs require or to get your existing wheels you would need to go with 16.5 inch tires. You mentioned you…

As long as your dual wheel has a flat surface where the Flange Wheel Nut #95188 would rest against, like what the Dexstar Dual Wheel #AM20790 has, then you would use this flange wheel nut in the place of a nut with a 90 degree cone. Attached is a…

You need the Wheel Retaining Ring #33-52-1 for your 10K axles and wheels. This ring has the single tab and will allow you to use your current flat faced wheel with Coned Lug Nuts #6-109. The retaining ring will sit outside the the wheels(see image).…

A spacer or hub-centric ring is sometimes used on passenger vehicles, but our resident wheel and tire guru tells me that they aren't needed for use on trailers, due to the weight load a trailer wheel will be under. If you feel you need them, you…

The wheel retaining rings are critical for lug piloted wheel setups. If your customers took this off and the wheel wasn't hub piloted and instead was lug piloted that would cause a lot of issues including studs sheering off.

Your Dexter axle is a 10,000lb general duty axle that was manufactured on 1/31/01. That is all information I was able to obtain from Dexter due to the age of the axle. It will use either the Dexter Trailer Idler Hub #8-288-3UC1 or the Dexter Trailer…

The wheel retainer ring that is included in certain hub assemblies like the Dexter #8-430-5UC3 that you referenced will be installed on dual wheels when tapered coned lug nuts like #6-109 are used instead of flange wheel nuts. It essentially allows…

The pilot hole for your wheel will need to be 4-3/4" or more to be used with Dexter Trailer Hub and Drum Assembly #8-219-13UC3. This is a lug-centric hub which uses lug nuts to secure the wheel to the hub and your wheel will need to have an 8 on…

I see that you are looking at the Westlake #LHAW124 ST225/75R15 Trailer Tire w/ Load Range E (2830 pounds maximum capacity) and would like to know if this tire is available with a higher load rating. Load Range E is the highest load rating for…

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…