Dexter 10,000LB Axle Wheel Retaining Ring Placement
Question:
My buddy has purchased this trailer with tandem 10k dexter axles. He removed all the wheels before I was able to see how they were installed. This is the wheel clamp ring that was on the wheels. I dont know how it is supposed to put on cause the two pins do not have a place to go for the clamp to sit flush with the wheel. The wheels are 6.5inch center lugs with oil filled hubs. There is an alignment pin on the hub and a single hole on each wheel to match. Here is a pic of the clamp that was on the wheel.
asked by: Jonathan C
Expert Reply:
You need the Wheel Retaining Ring # 33-52-1 for your 10K axles and wheels. This ring has the single tab and will allow you to use your current flat faced wheel with Coned Lug Nuts # 6-109. The retaining ring will sit outside the the wheels(see image). It looks like they likely placed the retaining ring on incorrectly when they switched the wheels and tires on the axle.
Products Referenced in This Question
- Accessories and Parts
- Boat Trailer Wheels
- Golf Cart Tires and Wheels
- Trailer Tires and Wheels
- Wheel Lug Nut
- 5/8 Inch Wheel Bolt
- Hex Nut
- 1-1/16 Inch Outer Diameter
- 90-Degree Cone
- Zinc-Plated Steel
- Dexter
more information >
Product Page this Question was Asked From
Wheel Retaining Ring - 9,000 to 12,000 lb
- Accessories and Parts
- Boat Trailer Wheels
- Golf Cart Tires and Wheels
- Trailer Tires and Wheels
- Retaining Ring
- Dexter
more information >
Continue Researching
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Shop: Wheel Retaining Ring - 9,000 to 12,000 lb
- Video: Dexter Axle Tires and Wheels 33-52-1 Review
- Shop: Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit
- Shop: Vehicle Tow Bar Wiring
- Shop: Vehicle Tow Bar Brake System
- Shop: Base Plate for Tow Bar
- Shop: Dexter Trailer Idler Hub Assembly for 9,000-lb to 10,000-lb Axles - 8 on 6-1/2 - Oil Bath
- Shop: Gooseneck Hitch
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Replacement Exterior Pop-Up Roof Vent - Aluminum - 13-1/2" x 8"
- Shop: Dexter Electric Trailer Brake Assembly - Self-Adjusting - 12-1/4" - Left Hand - 9K to 10K
- Shop: Van Cargo Mat
- Shop: Trailer End Connector - 4-Flat - Coiled
- Search Results: fold away coupler
- Search Results: rm~88400
- Q&A: What Is The Torque Spec For The 8-288-3UC1 Hub/Drum Assembly
- Search Results: 7 way connector
- Search Results: 7 way plug
- Video: Best 2021 Honda Pilot Trailer Hitch Options
- Search Results: 02475
- Search Results: 10~40
- Video: Dexter Axle Trailer Hubs and Drums - Hub - 8-288-3UC1 Review
- Search Results: akebrk~10
- Video: Buyers Products Trailer Wiring Junction Box Review
- Q&A: Determining Correct Oil Bath Seal For Dexter D100G 10000lb Axle
- Video: etrailer Self-Adjusting Electric Trailer Brake Kit Review
- Q&A: Best Way to Install Bushings Into Leaf Springs or Equalizer
- Video: Optronics Trailer Lights - Tail Lights - BUL12CB Review