Flat Tow Wiring for 2020 Jeep Gladiator and 2022 Chevy Equinox with LED Tail Lights

Question

Question:

Hi, I have base plates and tow bar for the 2 vehicles I have. I need tailight wiring kits for a 2020 Jeep Gladiator and a 2022 Chev Equinox. Both have LED tailights. I need the umbilical cord also to work with both. Thanks

asked by: Gary

0

Expert Reply:

Thank you for all of the information!

For your 2020 Jeep Gladiator I recommend using the Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit # RM-15267 and then for your 2022 Chevy Equinox with LED lights I recommend the Roadmaster Universal Wiring Kit # RO44FR and 6-Wire Trailer Connector # RM-910030-7.

The Jeep doesn't require special diodes so you can use the standard wiring kit and then pair up the umbilical with the special wiring and connector needed for the LEDs on your Chevy.

I've attached installation videos for the wiring kits on both vehicles for you to check out.

expert reply by: Jon G

0

Answer 1

All base plates are going to require you to trim the belly pan of your 2021 Jeep Gladiator - Rubicon. The only way to avoid that would be if you had a bumper with D-Ring Mounts that was rated to flat tow your vehicle. The Roadmaster Direct-Connect…

view full answer...

Answer 2

I would be happy to help you set your 2022 Jeep Gladiator for flat towing. You're going to need a base plate kit, a tow bar, tow bar wiring, supplemental braking system, protective screen, charge line, stop light switch, and a high/low adapter. I…

view full answer...

Answer 3

I looked up the owner's manual for your 2022 Jeep Gladiator. According to the manual, if you have a 4-wheel drive Gladiator, the ignition should be in the ACC position. However, if you must use the accessories (wipers, defrosters, etc.) while…

view full answer...

Answer 4

For your 2021 Jeep Gladiator the correct Blue Ox base plate kit is the part #BLU53FR. For lighting you can use the diode kit, #RM-15267, and not have to worry about cutting into the taillight housing. This will splice into your taillight wiring to…

view full answer...

Answer 5

There are 2 possible reasons why your install of the Flexo-Coil Wiring Kit #RM-15267 is causing an error to pop up on your 2021 Jeep Gladiator; the first is that something was installed incorrectly, and the second is that you have the ParkSense on…

view full answer...

Answer 6

The difference between the #RM-154 and the #RM-152-98146-7 is the trailer connector and the umbilical. The #RM-154 provides 4 circuits to the towed vehicle, right turn/brake lamp, left turn/brake lamp, running lamps and ground. The #RM-154 would…

view full answer...

Answer 7

We have great tow bar lighting solutions for your 2020 Jeep Gladiator but we don't have any plug and play options at this time. For lighting you can use the diode kit, #RM-15267, and not have to worry about cutting into the taillight housing.…

view full answer...

Answer 8

Yes, the Blue Ox Tow Bar Wiring Kit #BLU79FR would allow the use of a supplemental braking system and will transfer your motorhome's turning and braking signals through to your 2021 Jeep Gladiator's tail lights. This tail light wiring harness…

view full answer...

Answer 9

I'd recommend the Roadmaster Diode Kit part #RM-15267 which installs diodes on the taillight wiring of your 2022 Jeep Gladiator so that your motorhome can activate the taillights. I attached an install video for this kit on a similar 2021 Jeep…

view full answer...

Answer 10

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 11

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 12

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Flat Tow Wiring for 2020 Jeep Gladiator and 2022 Chevy Equinox with LED Tail Lights

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching