Overall Dimensions of Rack'Em Manufacturing Removable Wheel Chock Base

Question

Question:

May I know the size dimensions of the RA-17 base plate?

asked by: Ken

1

Helpful Expert Reply:

The overall dimensions of the Rack'Em Manufacturing Removable Wheel Chock # RA-17 are 10-1/2" wide x 10-1/4" long. It measures 8-9/16" from the base to the top of the chock and fits tires up to 6-1/2" wide.

expert reply by: Robin H

1

Answer 1

The part number for the base plate used in the Rack'em Manufacturing Removable Wheel Chock part #RA-17 is the Steel Replacement Base part #RA-17B. Please keep in mind that this is the base plate only and you will need to supply your own hardware…

view full answer...

Answer 2

We haven't had anybody confirm a fit for a Spyder hauler, but I can confirm that the highest point of the Rack'em Wheel Chock #RA-17 from the ground is 8-9/16". If you measure from the ground to your fender you will be able to tell if it…

view full answer...

Answer 3

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 4

Hey Jerry, the install of the Aries Bull Bar part #AAB35-4015 do require you to permanently remove the tow hooks to install. It looks like the similar Westin Ultimate Bull Bar part #32-3645 does allow you to keep them though.

view full answer...

Answer 5

From what we have found, the Nissan factory brake controller harness has the following color/functions: Nissan Red to brake controller black for 12-volt power Nissan Red with green tracer to controller red for input from stoplight Nissan black to…

view full answer...

Answer 6

I checked with Erickson and their Removable Motorcycle Wheel Chock item #EM07506 does not have a weight rating. It is made of steel and works with bikes that have up to 6" tires. So long as your Honda and Kawasaki do not have wider tires this…

view full answer...

Answer 7

The best solution is going to be to go with a double eye leaf spring setup instead of what you have now. For that the leaf spring part #e57SR is for a 4,000 lb axle and has a 25-1/4 inch length from eye to eye. Then for a hanger kit you'd want…

view full answer...

Answer 8

Hey Joel, we have bike racks that will work for you but the Inno bike rack part #IN25RR only fits up to 3-1/2 inch wide tires. The Kuat Piston Pro bike rack part #KU66ZR would work great as it can fit a bike tire width up to 5 inches.

view full answer...

Answer 9

The equalizer of a tandem axle trailer is not the balance point of the trailer. I would recommend putting the wheel chocks of your trailer as far forward as you can in the trailer. This will help prevent any potential sway that can occur from not…

view full answer...

Answer 10

To use the Detail K2 II snow plow part #K2RAMP8219 on your 2021 Toyota Tundra the correct install kit is the part #K285113.

view full answer...

Overall Dimensions of Rack'Em Manufacturing Removable Wheel Chock Base

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching