How To Determine The Correct Heating Pad Replacement For A Thomas Payne Recliner

Question

Question:

Does the power output for the heating pad put out 12v or 29v? mine is putting out 12v but the replacement heating pad calls for 29v.

asked by: GEORGE N

0

Expert Reply:

If your Thomas Payne recliner has the power recline function, then the 29 volt, # 674864 is the correct heating pad replacement.

If not, then the Replacement 12 Volt Seat Heating Pad for Thomas Payne RV Theatre Seating # LC38UD is the correct replacement.

expert reply by: Bryce D

0

Answer 1

I spoke with my contact at Lippert who said that either the heater is bad or the control box needs to be replaced on your Thomas Payne Momentum recliner. To test the heater unplug the red and black wires from the control box (located behind and…

view full answer...

Answer 2

Thomas Payne does not offer specific instructions for installing the Replacement Heater Pad #674864 that you referenced but it's more or less disassembling the couch cushions to access the pad, unplugging and remove the old heater and…

view full answer...

Answer 3

You will have to go from the side or underneath. Then you can unplug and remove the old pad and replace it with the Replacement 29-Volt Seat Heating Pad for Thomas Payne Seismic Series RV Couches and Chairs #674864. If you need to replace the…

view full answer...

Answer 4

I cannot recommend you alter the location of the heating pad on the Thomas Payne Seismic Dual Power Reclining RV Loveseat. That said, if you do not wish to have the heated seat feature this can be turned off via the controls on the cup holder. If you…

view full answer...

Answer 5

I apologize for your issues with your heating pads! The Replacement 12 Volt Seat Heating Pad for Thomas Payne RV Theatre Seating #LC38UD is the same pad as the 354491. The 354491 is the Lippert part number and the #LC38UD is the part number here at…

view full answer...

Answer 6

We do have some replacement heating pads for your Thomas Payne recliner's. Depending on what series you have, we may have a solution for you. If you have the Thomas Payne Theater seating, #LC38UD will work for you. If you have the Seismic Series…

view full answer...

Answer 7

The replacement part you need is the Replacement 12 Volt Heating Pad For Thomas Payne RV Theatre Seating, part #LC38UD. I have included a product description link below.

view full answer...

Answer 8

Hi Dan; I can definitely help you find these parts for your 2020 Grand Design Imagine 2500RL. I reached out to Dexter and found that the leaf springs that came with your axle measure 26" so you will want to match that when replacing them. Since…

view full answer...

Answer 9

Assuming your Sprinter has the factory tow package with the 7-way at the rear bumper, in addition to the #RED24FR Redarc Tow-Pro Liberty Brake Controller, you'll also need the #3063-P wiring harness and the #331-TPH-017. The connector to install…

view full answer...

Answer 10

I recommend using the Roadmaster Comfort Ride Shock Absorbers #RM-2450 and the MORryde AllTrek 4000 Equalizers #MR29DR on your 2017 Grand Design Imagine 2600RB travel trailer. These will fit your 3,500lb axles and replace your stock equalizer. You…

view full answer...

Answer 11

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 12

Yes, you are correct. In order to correctly take this measurement you will need to measure from the center of the spindle to the center of the main axle tube. I have included a picture for reference.

view full answer...

How To Determine The Correct Heating Pad Replacement For A Thomas Payne Recliner

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching