What Type PEX Fitting on Clearsource Onboard Pro RV Water Filter System w/ VirusGuard

Question

Question:

Would the threads be 1/2 npt so I can unscrew there fittings pex b and change it to 1/2 npt to pex a

asked by: Chris B

0

Expert Reply:

I checked with the manufacturer, they only use the one type of fitting on the Clearsource Onboard Pro RV Water Filter System w/ VirusGuard, # CS59FR, and is compatible with either Type B or Type C.

expert reply by: Michael R

0

Chris B.

2/15/2022

Would the threads be 1/2 npt so I can unscrew there fittings pex b and change it to 1/2 npt to pex a

Reply

Michael R.

2/15/2022

The fittings have been permanently installed with epoxy to ensure against leaks. The threads on the filter housings are 3/4” NPT.

Reply

Answer 1

I can't speak specifically about any one water pump as they are not all the same but when asked about water pressure, this is what Clearsource had to say in reference to the Clearsource Onboard Pro RV Water Filter System part #CS59FR. "The…

view full answer...

Answer 2

Hey Morris, you want to measure from the width of the flange that runs around the edge of the slide out to pick out the correct slide topper. Based on the dimension you took the part #LCV000165061 that you referenced is probably correct but you still…

view full answer...

Answer 3

When choosing the slider you want to measure the outside front of box width including the flange. Then you need to select a slider that extends a minimum of 2-1/2 inches beyond each side of the box width. For example, the Black Solera Slider…

view full answer...

Answer 4

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 5

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 6

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 7

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 8

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 9

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 10

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 11

We do have the Rhino-Rack Masterkey Lock Barrels #RRRK093-2 which will provide you with 2 new lock cores and keys for your Rhino-Rack Zenith MasterFit Rooftop Cargo Box #RRRMFZ66. As far as pricing goes on the different sets they can change based on…

view full answer...

Answer 12

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

What Type PEX Fitting on Clearsource Onboard Pro RV Water Filter System w/ VirusGuard

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching