Height of Timbren Aeon Hollow Rubber Springs for Rear Axle on 2022 Ford F-250 Super Duty

Question

Question:

What is the height of the rubber part on these?

asked by: Grant

0

Expert Reply:

The height of the Aeon hollow rubber springs on the Timbren Suspension Enhancement System - Rear Axle # TFR250SDJ is 4-1/2". The overall height for the Timbren system is 6-7/8".

See the helpful diagram below which shows both measurements. I have also attached a review video for your reference.

expert reply by: Robin H

0

Timbren TFR250SDJ Measurements.
(click to enlarge)

Answer 1

Hey Frankie, The bracket for the Timbren Suspension Enhancement System #TFR250SDJ has a locknut in it that makes it feel like the bolt (part #4) is fully tightened when it's not. Their techs have stated that you just have to push past this…

view full answer...

Answer 2

The Timbren Suspension Enhancement System - Rear Axle #TFR250SDJ are a fit for both a two-wheel drive as well as a four-wheel drive 2020 Ford F-250 Super Duty. The spring by itself (without the bracket) measures 4-1/2 inches, and with the bracket…

view full answer...

Answer 3

I would recommend sticking with the amount of space you have now with your Timbren #TFR250SDJ because if you use a spacer to take up any more space you'll end up with a harsher ride quality. What you can do is try it without the spacer and…

view full answer...

Answer 4

The correct Timbren Suspension Enhancement System for your 2019 Ford F-350 Super Duty is the #TFR350SDJ. The #TFR250SDJ only fits the F-250. Unless you have altered your suspension this should fit as intended by the manufacturer. Ideally you want…

view full answer...

Answer 5

For Timbrens that will work with your 2022 Ford F-250 with a severe service kit, I recommend the Timbren Suspension Enhancement System - Rear Axle #TFRTT350J. This kit is designed to be used with vehicles with a slide-in camper, salt spreader, or a…

view full answer...

Answer 6

We have a large selection of RV steps available that may work great on your 2016 Forest River Prime Time Crusader. When trying to locate a step assembly that will fit your trailer, you will first want to determine the mounting base measurements of…

view full answer...

Answer 7

Verify the distance from the threshold to the front of the StepAbove hinge plate it should be 15/16". There should also be 1/8" clearance between the inside lip on the door jamb and the outside edge of the step on each side. Check to make…

view full answer...

Answer 8

The springs themselves included with the Timbren Rear Suspension Enhancement System #TFR250SDJ for your 2020 Ford F-250 measure 4-1/2" tall. When the mounting bracket is added you're looking at a total overall height of 6-7/8". I have…

view full answer...

Answer 9

The combined height of the Timbren Suspension Enhancement System - Rear Axle #TFR250SDJ is 6-7/8 inches. I went out to our warehouse to measure them for you and also have attached a photo for you to see where the measurement was taken.

view full answer...

Answer 10

The towing capacity of your 2018 Ford F-250 will vary based on factors such as engine size, axle ratio, and GCWR. These figures will range from 12,800 lbs on the low end to 18,500 lbs on the high end. If you can provide me with the engine size, axle…

view full answer...

Answer 11

All you would need to install the Air Lift LoadLifter 5000 Ultimate Air Helper Springs with Internal Jounce Bumpers #AL88396 on your 2014 Ford F250 with a 3-1/2 inch lift kit is the correct lift spacer kit. For that you would need the spacer kit part…

view full answer...

Answer 12

If you have a lifted 2017 Ford F-250, you will need spacers with Air Lift airbags like the Air Lift LoadLifter 5000 Ultimate Plus Air Springs w/ Internal Bumpers #AL89399 (4-wheel drive) or the Air Lift LoadLifter 5000 Air Helper Springs - Rear Axle…

view full answer...