MORryde StepAbove RV Steps Door Rubs Upon Closing 2019 Prime Time Avenger

Question:

i have a 2019 avenger by prime time. when i installed the #mr48rr steps. i put in the first two screws and the door closed ok. after i put in the rest of the screws the door rubs the bottom.

asked by: NUMON R

Helpful Expert Reply:

Verify the distance from the threshold to the front of the StepAbove hinge plate it should be 15/16". There should also be 1/8" clearance between the inside lip on the door jamb and the outside edge of the step on each side.

Check to make sure when the steps are out the extension feet aren't out too far keeping the hinged plate across the threshold up. That could cause the door not to shut.

Additionally you may need to adjust the length of your steps using the adjustable ends. Make them shorter and the steps go down more allowing doors to properly close.

I did reach out to MORryde, and they mentioned that your door hinges may not be square with the door frame. To correct this you can pull up on the underside of the door to square the hinges and it should alleviate the rubbing.

expert reply by: Bryce D