What Should Loadstar 205/65-10 Load Range C Tires AM1HP52 be Inflated to

Question

Question:

i have a tow dolly and pull a nissan versa. front axle weight is 1650 lbs. my tires are loadstar 205/65-10. i have 40 lbs air pressure in the tires. is that air pressure ok , or shud the air pressure be more like 50 lbs?

asked by: Stu W

1

Helpful Expert Reply:

For any trailer (including dolly) tires such as your Loadstar # AM1HP52, you always want to inflate them to the maximum cold psi, which on this tire is 50.

Doing this will give you the best performance, allowing the tire to wear slower and more evenly and ensure not only it meets its load rating but also speed rating.

expert reply by: Kyle S

1

Answer 1

The 205/65-10 trailer tire size comes in different load ranges and each load range has a different psi requirement. A load range B in this size should be inflated to 35 psi. Load range C inflate to 50 psi. For load range D inflate to 70 psi. And for…

view full answer...

Answer 2

The speed rating of the Kenda Loadstar 205/65-10 Bias Trailer Tire with 10" Solid Center Wheel #AM3H454 you were looking at is 87 mph. This tire and wheel combo has a 5 on 5-1/2 lug pattern and a maximum load capacity of 1,650 lbs at 90 psi.

view full answer...

Answer 3

The 205/50-10 is the modern replacement size for the 20.5x8-10 tire. The #AM3H454 wheel/tire combo you specified has a 1650 lb per tire capacity. My research indicates that the 20.5x8-10 Load Range F tire had a 1765 lb per tire capacity which is…

view full answer...

Answer 4

In the tire size and bolt pattern size you need we only have white wheels. The bolt pattern you have is not the most popular so that's why the options are a bit limited. So you would need the part #AM3H454 which has the correct tire size and…

view full answer...

Answer 5

The correct air pressure for your Kenda Loadstar 205/65-10 tires will be dependent on the load rating of your tires, and you will want to make sure they are aired up to the maximum PSI of the tire which will be stamped on the sidewall. Also go ahead…

view full answer...

Answer 6

Trailer tires should always be inflated to the maximum psi as indicated on the tire regardless of the load on the trailer. The reason for this is because of how trailer tires are constructed. Trailer tires are made with a thicker sidewall than…

view full answer...

Answer 7

Special trailer tires should be inflated to their maximum air pressure. The value for the maximum air pressure should be listed along with the value for the maximum load on the tire's sidewall. These values will usually designate the maximum load…

view full answer...

Answer 8

The tires in your size that we offer have varying pressure ratings depending on their load capacity. For example, if you look at the tires in your size shown on the link I have included you will see that those rated for Load range E, such as…

view full answer...

Answer 9

Trailer tires should always be inflated to the max PSI rating that is on the sidewall of the trailer. The same size tire may have different pressure ratings based on Load Ranges, brands etc. For the size you listed of 205/65-10 common pressure…

view full answer...

Answer 10

On the sidewall there will be the tire pressure recommended for it. There isn't a recommended tire pressure that applies for every tire that has the 205-65-10 size that you referenced. The part #AM1HP52 for example has a PSI rating of 50 psi.…

view full answer...

Answer 11

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

view full answer...

Answer 12

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

What Should Loadstar 205/65-10 Load Range C Tires AM1HP52 be Inflated to

Product Page this Question was Asked From

Continue Researching