Locking Knob that has M8 1.25 Thread Pitch

Question

Question:

Hi Does this fit M8 bolts with a 1.25 pattern? If it dose not , do you have any other locking knob to do so ? Thanks

asked by: Alain

0

Expert Reply:

We have the Thule Replacement Anti-Rattle Knob part # 753-0073 which fits the M8 1.25 thread size/pitch. Then to install a lock core you'd need the part # 1500004217 with the change key # 853-1251.

expert reply by: Jameson C

0

Answer 1

We do have the replacement rubber strips for the Thule WingBar Evo crossbars, and like you said they are in fact different than the AeroBlade. The correct part for your WingBar crossbars is the following: - Replacement QuickAccess Interface Top…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

Typically the lock will need to be in the unlocked position in order to unscrew the Locking Anti-Rattle Knob for Thule Apex Bike Racks and Rain Gutter Foot Packs - Qty 1 #753-0073 from the locking hitch pin. If your lock was in the locked position…

view full answer...

Answer 4

The Replacement Gutter Foot for Thule Gutter Feet #753-0687 is not one of the high towers. Although Thule was unable to provide me with exact measurements, I can tell you these have a 5" clearance above the rain gutters.

view full answer...

Answer 5

Thanks for the picture. Based on that what you would need is the part #TH68JH that you mentioned.

view full answer...

Answer 6

We just go with a blanket "no" statement for that question because the Thule Replacement Locking Anti-Rattle Knob #753-0073 will definitely fit with Thule cores. We've been told by all of our rec manufacturers (Thule,…

view full answer...

Answer 7

To replace the anti-rattle knob on the Thule T2 Pro XTR Bike Rack for 4 Bikes #TH69TX you'll actually have to replace the whole lower assembly with part #TH37MY. Unfortunately that anti-rattle knob isn't available by itself which is why you…

view full answer...

Answer 8

The Replacement Locking Anti-Rattle Knob for Thule Apex Bike Racks and Rain Gutter Foot Packs #753-0073 does have a threaded M8 x 1.25 internal section so you can re-thread it onto your bike rack. Since that's what sounds like got hollowed out,…

view full answer...

Answer 9

Since the tightening knob for your Thule Apex 9026 bike rack (replaced by the Apex XT #TH9026XT) is spinning you want to first verify that the key is in the unlocked position. This bike rack had a neat feature where the knob would just free-spin when…

view full answer...

Locking Knob that has M8 1.25 Thread Pitch

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching