Fulton 900 lb Winch to Replace T900

Question

Question:

I need a repair kit for a fulton t900. The one with the ratchet spring and sleeve. I dont see it listed on the site. Can you get one?

asked by: Zach W

0

Expert Reply:

We used to have the older Fulton winch repair kits but they stopped making them a while back and we can no longer get them. For a similar 900 lb capacity winch from Fulton we have the part # F142007 which would work great. This comes with a 12 foot long strap as well.

expert reply by: Jameson C

0

Answer 1

The Fulton Single Speed Trailer Winch part #F142102 uses a standard winch mounting pattern which I have attached a photo of for you. If your winch mounting pattern does not match this then your would be best off to just re-drill as most boat trailer…

view full answer...

Answer 2

When using a bolt-on coupler such as the Demco #DM14793-52, trailer coupler locks such as the Master Lock #ML389DAT are added to prevent trailer theft. These locks are an inexpensive and large deterrent to those looking to steal a trailer. There is…

view full answer...

Answer 3

The extra loop is referred to as a hand saver loop. It simply provides a safer place to grab the end of the strap for when you're pulling out slack from the winch drum. The snap hooks can get torn up a little, and could be rough on your fingers…

view full answer...

Answer 4

The 25 Ft 4-Way Trailer Wiring Harness #A25W2GWB uses 18 gauge wire for the ground wires and 20 gauge wires for the light functions. The Wiring is copper and not aluminum.

view full answer...

Answer 5

The Atwood Trailer Coupler 81911 that you have on your A-frame trailer can be locked in two ways, by securing the latch and by blocking entry of a hitch ball. The latch mechanism on the top can be locked with an item like the Dead Bolt #e98884. (This…

view full answer...

Answer 6

In your situation I really like the Fulton Single Speed Trailer Winch part #F142007. While it does not have a handle that switches from side to side it is not common to find that. This will give you all of the power you need and the way they are…

view full answer...

Answer 7

The Dutton Lainson Worm Gear Hand Winch, #DL11001, can lift up to 2,000 lbs, so it should have no problem lifting your dock out of the water, assuming the dock does not weigh more than 2,000 lbs. This winch also comes with a hex head drive that will…

view full answer...

Answer 8

The inside width of the CE Smith Bow Roller Bracket #CE31005PG has an internal width of 3-11/16 inches so for a winch that is narrow enough to fit inside that we have the #DL16001 which measures 3-3/16 inches in width.

view full answer...

Answer 9

No, there is no minimum amount of weight required for worm gear winches such as #DL11001. I have linked a video review of this winch for you.

view full answer...

Answer 10

The Dutton-Lainson Hand Winch with TUFFPLATE Finish, Two Speed with Direct Drive - 3,200 lbs, #DL15440 will work for your application very nicely, however I have another option for you to consider. I recommend the Dutton-Lainson Worm Gear Hand Winch…

view full answer...

Answer 11

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 12

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Fulton 900 lb Winch to Replace T900

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching