Replacement Bunk Boards for a Boat Trailer

Question

Question:

I am needing new bunks for my boat trailer. It has 2 pairs of bunks, both are 2x6 material. One pair measures 10’-6” and the other measures 5’-4” long. What do you have available?

asked by: Bill N

0

Expert Reply:

We do have a selection of bunk boards available which you can use for a variety of lengths. Below are the different lengths we carry:

2' - # CE27850
3' - # CE27800
4' - # CE27810
5' - # CE27820
6' - # CE27840
7' - # CE27845

Since bunk board brackets can sit at different locations along the boat frame you'll just need to compare the different lengths to what you currently have and you'll be good to go!

expert reply by: Jon G

0

Answer 1

It sounds like you are looking for bunk board carpeting. The closest we have to your 18 inch by 20 foot is the CE Smith Deluxe Marine-Grade Carpeting for Bunk Boards - Gray - 18' Long x 18" Wide #CE11373 or Black #CE11349. This will give you…

view full answer...

Answer 2

The most common way to attach bunk carpet to bunk boards is to use heavy duty staples on the underside of the bunk and then an outdoor carpet adhesive on the tops of the boards. A coworker here used Liquid Nails as an adhesive when he did his two…

view full answer...

Answer 3

In the video I attached on re-carpeting boat bunks we used lag bolts to attach the bunks to the hardware. Skip ahead to the 3:00 minute mark to see this.

view full answer...

Answer 4

The longest bunk boards we offer pre-wrapped are the CE Smith Carpeted Bunk Boards for Boat Trailers part #CE27845 which measure 7' long. For longer boats, you'd simply install multiple bunk boards on the same side until you have the desired…

view full answer...

Answer 5

I have a solution for you, but unfortunately those 7ft long bunk boards #CE27845 are going to be the longest ones we currently offer. If you wanted to source the wood yourself you could then just use some marine grade carpeting like the CE Smith…

view full answer...

Answer 6

So the U-Bolt will secure the CE Smith Light Duty, Vertical Bunk Bracket #CE10603G with the ends pointing towards the back of the trailer. If you look at the picture you took it looks like those fasteners holding your current brackets could be…

view full answer...

Answer 7

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 8

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 9

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 10

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 11

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 12

To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…

view full answer...

Replacement Bunk Boards for a Boat Trailer

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching