Can Trailer License Plate Holder with LED Light be Installed on Ramp Door of Enclosed Cargo Trailer
Question:
Will this work on a ramp door on my enclosed trailer?
asked by: Dwayne
1
Helpful Expert Reply:
You can definitely install the Trailer License Plate Holder with LED Light # 328-003-71BE on the ramp door of your trailer. You'll just have to route enough wire that it doesn't get pulled apart when you lower the door, and you'll also want to make sure that you protect it from weight being placed on it so that it would break.
expert reply by:
Jon G
1
Product Page this Question was Asked From
Trailer License Plate Holder with LED Light - 3 Diodes - Clear Lens - Black Frame
- Trailer Lights
- License Plate Lights
- Rectangle
- Surface Mount
- Non-Submersible Lights
- LED Light
- 15-1/2L x 9-1/2W Inch
- White
- Command Electronics
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements
- Q&A: Replacing A 125255UC Double Lip Grease Seal
- Q&A: Where are Taskmaster and Westlake Trailer Tires Made
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Common Torque Specifications for Lug Nut Size
- Q&A: Lug Nut Torque Recommendation for Dexter Hub # 8-219-4UC3-EZ to 17.5 inch Wheel
- Article: Trailer Tire Sizing
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: Can I Use the Rhino Rack Batwing on a Tear Drop Trailer with a Rear Hatch That Opens 12" Above Roof
- Q&A: Torque Spec for Installation of Yakima Exo SwingBase Swing Away Hitch Extender Tongue
- Q&A: Upgrading from 205/75-15 Trailer Tires to 225/75-15 Trailer Tires
- Article: Hard Tonneau Covers vs Soft Tonneau Covers
- Article: How to Measure a Trailer Axle