Both Signals Blink When Activating Left Turn Signal After Installing Curt Converter C59236
Question:
i got the wire harness 4 pin for my 2010 Audi A4 and installed. Break, Running and Right turn work good. When the left turn is put on both right and left blink. Please help me figure out how to connect wires to car.
asked by: Kirk B
Expert Reply:
Really the only reason that both the right and left signals would blink when you activate the left turn signal is insufficient ground on the Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector part # C59236. You want to make sure the ground of the wiring harness is attached to a clean bare metal surface of the Audi's frame free of paint or debris. I have attached a helpful article on 4-way wiring for your reference.
Product Page this Question was Asked From
Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- Universal Fit
- 4 Flat
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Q&A: How To Display a License Plate With a Bike Rack Attached
- Shop: Draw-Tite Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"
- Video: Trailer Hitch Installation - 2003 Toyota Avalon - Draw-Tite
- Q&A: What is the Difference Between Hopkins and Curt Trailer Wiring for a 2011 Dodge Grand Caravan
- Shop: Hopkins Active Tail Light Converter with Install Kit
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Video: Choosing the Right Trailer Wiring
- Video: Hopkins Tailight Converter Kit Installation - 2000 Lexus RX 300
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Tekonsha OEM Replacement Vehicle Wiring Harness with 7-Way Trailer Connector
- Shop: Curt Powered Tail Light Converter w/ 4-Way Flat Trailer Connector and Install Kit
- Search Results: 44649
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Video: Tow Ready 4-Pole Mounting Bracket Installation
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Search Results: 68149
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Adding Brakes to a Mobile Home Axle
- Video: Choosing the Right Brake Controller
- Shop: Brake Controller
- Search Results: 25580
- Article: How to Measure for Trailer Hitch Drop
- Shop: Fifth Wheel Hitch
- Search Results: dust cap
- Q&A: How to Determine if Trailer Axle is Not Aligned and How to Measure to Replace Trailer Axle