Will Ultra-Fab RV Trailer Hitch Receiver Extend Past Rear Bumper On Winnebago 2106 Trailer

Question

Question:

Is the Ultra-Fab 35-946403 receiver long enough to come out past the rear bumper on the trailer? Or at least to the outer edge. Thanks for ur help!

asked by: Buddy A

0

Expert Reply:

The Ultra-Fab 2" Trailer Hitch Receiver for Trailer Frames # UF35-946403 is a weld on trailer hitch receiver compatible with frames 47-1/8" to 77". It is compatible with I-beam, C-channel, or rectangular trailer frames. The receiver tube opening will be 5-1/4 inches out from the crossbar. This will not stick out past your bumper on your Winnebago 2106, but will still be close enough for most accessories like a bike rack or cargo carrier.

expert reply by: Jason S

0

click to enlarge

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 4

To me it makes the most sense to put a Bike Rack #HLY64FR on the flat towed vehicle rather than above the tow bars. Especially on heavy e-bikes as they are difficult to lift that high onto the rack, but also as it only makes sense to have the rack on…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The first thing you'll need to flat tow your 2015 Chevy Malibu LS is a base plate kit like the Roadmaster part #RM-523178-5 that is a confirmed fit. In addition to the base plates, you will also need a compatible tow bar, safety cables, lighting,…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

When it comes to choosing between the Blue Ox Patriot #BLU37TR and the Brake Buddy Select 3 #HM39524, these systems are extremely similar in their setup and functionality. Both of these systems provide proportional braking in a compact and easy to…

view full answer...

Will Ultra-Fab RV Trailer Hitch Receiver Extend Past Rear Bumper On Winnebago 2106 Trailer

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching