Installing a 7-Way Trailer Connector and Brake Controller on a 2014 Porsche Cayenne
Question:
I bought a 7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket and Curt Class III Receiver Hitch for my cayenne diesel 2014. What else I need to wire it to my trailer.
asked by: Carlos F
Expert Reply:
Trailer connector # HM40975 that you purchased is meant as a replacement for a 2014 Porsche Cayenne that came with a factory 7-Way trailer connector. If yours did not then it will have to be hardwired in.
The first part you will need is harness # PK11998 which plugs into the back of connector # HM40975. Next, you will need to install a wiring converter, # C59496, which hardwires into the tail light wiring on the vehicle.
Then, after the # C59496 is installed you will cut off the 4-Way end and hardwire the wires from it to harness PK11998 as follows:
White wire to white wire (I would also then ground both to the vehicle frame)
Yellow wire from C59496 to red wire on PK11998
Green wire to green wire
Brown wire to brown wire
Yellow on PK11998 is for reverse lights. If needed it will need to splice into a reverse light wire
That will leave blue and black wires. The blue wire is for electric trailer brakes and requires a brake controller in the vehicle. The black wire is for 12 volt power. So you will need wiring kit # 5506 which comes with wire, circuit breakers (you will need the 30 amp and 40 amp breakers from the kit) and other parts to wire up the blue and black wires.
There are some special circumstances on the Cayenne when you install a brake controller. You will need the following parts that are available from a Volkswagen dealer:
1 connector housing (#1J0-972-782) and
2 wire/terminal assemblies (#000-979-228)
Cut the wires from both wire assemblies in half so that you have 4 wires, each with a clip on one end and bare wire on the other. Connect the bare end of each of these wires to one of the wires on your brake controller, then slip the other end of each wire into its appropriate slot on the housing. The slots are numbered to make it easier to connect each wire correctly. I have included a link to a help article that covers this.
For a brake controller I recommend the Brake EVN # TK63VR because with it you will not have to go through the special installation (besides what is listed above) involving relays (noted in the help article I have linked).
Products Referenced in This Question
Wiring Kit for 2, 4, 6, and 8 Brake Electric Trailer Brake Controllers
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Curt Powered Tail Light Converter w/ 4-Way Flat Trailer Connector and Install Kit
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- 8 Feet Long
- Universal Fit
- 4 Flat
- CURT
more information >
4' Pigtail Wiring Harness for Pollak Replacement 7-Pole RV Socket
- Accessories and Parts
- Trailer Wiring
- Vehicle Wiring Harness
- Universal
- 7 Blade
- Pollak
more information >
Tekonsha BRAKE-EVN Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Automatic Leveling
- Under-Dash Box
- Up to 4 Axles
- LED Display
- Up to 90 Degrees
- Tekonsha
more information >
Product Page this Question was Asked From
7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket - Vehicle End
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 7 Round - Blade
- 4 Flat
- Hopkins
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Wiring
- Shop: Brake Controller
- Shop: Trailer Hitch
- Article: 2005-Current Volkswagen Touareg, Audi, or Porsche Cayenne
- Video: Curt Trailer Hitch Installation - 2017 Porsche Cayenne
- Shop: 7-Way RV Upgrade Kit for Trailer Brake Controller Installation - 12 Gauge Wires
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Shop: Curt Mounting Bracket for 4-Pole Flat Trailer Connector
- Shop: Towing Kit w/ Ball Mount and Trailer Wiring for Stealth Hitches Hidden Rack Receiver - 2" Ball
- Shop: Curt Echo Wireless Brake Controller - 7-Way Plug Mount w/ Bluetooth App - 1 to 2 Axle - Proportional
- Shop: Autowbrake Electric Brake Controller - Trailer Mount w/ Remote Fob - 1 to 3 Axles - Proportional
- Search Results: gooseneck adapter
- Shop: Gooseneck Hitch
- Search Results: etbc7l
- Search Results: c51180
- Video: Choosing the Right Trailer Wiring
- Search Results: 119191
- Search Results: fuse
- Search Results: 119190kit
- Search Results: 119193
- Article: 5 Things to Know About Weight Distribution Hitches
- Video: Review of Equal-i-zer Replacement Parts - L Pins - EQ95-01-9430
- Q&A: Recommended Trailer Hitch for 2018 Porsche Cayenne
- Q&A: Wiring for Trailer Towing With 2016 Porsche Cayenne
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Q&A: Comparing Reese Weight Distribution RE94FR to Fastway e2 FA94-00-0600
- Q&A: Recommended Weight Distribution System for 5000 lb Starcraft Launch Travel Trailer
- Q&A: Weight Distribution Hitch Recommendation for a Camper Trailer
- Q&A: Weight Distribution Recommendation for Airstream RB16 Caravel Camper