How to Pick Out Hub and Lighting for Harbor Freight Trailer
Question:
Hi, I have a 4x8 utility trailer, harbor freight kind, it has the 4 lug wheels and hubs. I would like to carry a jet ski on it which would mean that it will be backed down a boat launch. This will be fresh water only so I think the trailer can handle being wet. However, the bearings and lights on the current set up probably can’t handle water well. I believe this is the hub that would go on my trailer for reference AKIHUB-440-2-1K What hubs and lights would I need to retrofit this trailer to be somewhat water compliant?
asked by: Tom S
Expert Reply:
You are going to have to pull a hub off your trailer to determine if the hub you referenced would fit it. We have to match either spindle dimensions or bearing numbers to know if the part # AKIHUB-440-2-1K is a correct replacement.
The bearings of this hub are:
Inner bearing: L44643 (1" inner diameter)
Outer bearing: L44643 (1" inner diameter)
For a submersible LED trailer light kit the part # TLL9RK is our most popular submersible option and would work well. I attached an install video for more info.
Its recommended that you unplug the trailer wiring when you back the trailer into water.
Products Referenced in This Question
LED Combination Tail Light Kit for Trailers under 80" Wide - Submersible - Driver and Passenger
- Trailer Lights
- Tail Lights
- License Plate
- Rear Reflector
- Side Reflector
- Stop/Turn/Tail
- Square
- Kit
- Surface Mount
- Submersible Lights
- LED Light
- 5L x 5W Inch
- Red
- Optronics
more information >
Product Page this Question was Asked From
Trailer Idler Hub Assembly for 2,000-lb Axles - 4 on 4 - L44643 Bearings - Pre-Greased
- Trailer Hubs and Drums
- Hub
- Pre-Greased
- Standard
- L44643
- L44643
- For 2000 lbs Axles
- 1/2 Inch Stud
- 4 on 4 Inch
- 8 Inch Wheel
- 10 Inch Wheel
- 12 Inch Wheel
- 13 Inch Wheel
- 14 Inch Wheel
- etrailer
more information >
Continue Researching
- Q&A: How to Tell if Trailer has a BT8 or BTR Spindle Installed
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Replacement 1/2-20 Wheel Stud For Reliable 1206 Trailer Hub
- Article: Most Popular Wheel Bearings
- Article: Rooftop Cargo Carriers
- Q&A: What Is the Difference Between a BTR and BT8 Spindle
- Article: RV and Camper Types, RV Classes
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Trailer Tire Sizing
- Q&A: Trailer Hub Recommendation with 4 on 4 inch Bolt Pattern and Bearings L44643
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Q&A: Solution for Replacing Dexter 8-222 Trailer Hubs and Bearings
- Q&A: What is Angle of Redline A-Frame Coupler, part # CA5400